TG341xBX(e).book Page 24 Thursday, March 3, 2011 1:47 PM
Useful Information
Caller ID
Problem | Cause/solution |
Caller information is not | L You must subscribe to Caller ID service. Contact your |
displayed. | service provider/telephone company for details. |
| L If your unit is connected to any additional telephone |
| equipment such as a Caller ID box or cordless telephone |
| line jack, plug the unit directly into the wall jack. |
| L If you use a DSL/ADSL service, we recommend |
| connecting a DSL/ADSL filter between the base unit and |
| the telephone line jack. Contact your DSL/ADSL provider |
| for details. |
| L Other telephone equipment may be interfering with this |
| unit. Disconnect the other equipment and try again. |
Caller information is displayed | L Depending on your service provider/telephone company, |
late. | the unit may display the caller’s information at the 2nd |
| ring or later. |
| L Move closer to the base unit. |
Liquid damage
Problem | Cause/solution |
Liquid or other form of moisture | L Disconnect the AC adaptor and telephone line cord from |
has entered the handset/base | the base unit. Remove the batteries from the handset and |
unit. | leave to dry for at least 3 days. After the handset/base |
| unit are completely dry, reconnect the AC adaptor and |
| telephone line cord. Insert the batteries and charge fully |
| before use. If the unit does not work properly, contact an |
| authorized service center. |
Caution:
LTo avoid permanent damage, do not use a microwave oven to speed up the drying process.
Registering a handset to the base unit
1Handset:
{j/OK}
2{r}: “Settings” s{j/OK}
3{r}: “Register HS” s{j/OK}
4Base unit:
Press and hold {x} for about 5 seconds. (No registration tone)
L If all registered handsets start ringing, press {x} again to stop, then repeat this step.
L The next step must be completed within 90 seconds.
5Handset:
Press {j/OK}, then wait until a long beep sounds.
L When the handset has been registered successfully, w stops flashing.
24
