Panasonic KX-TG7100, KX-TG7123E Registering a handset to, Base unit, Additional handsets

TG7100-7120E(e).book Page 28 Tuesday, July 4, 2006 3:29 PM

Multi-unit Operation

				3 Place the additional handset on the
Operating additional units						base unit. The registration tone
						continues to sound. With the handset
						still on the base unit, wait until a
Additional handsets						confirmation tone sounds and w stops
Up to 6 handsets can be registered to the						flashing.
				Note:
base unit. Additional handsets will give you
the freedom to, for example, have an				L If an error tone sounds, or if w is still
intercom call with another handset while a					flashing, register the handset manually
third handset is on an outside call. See page					(manual registration; page 28).
5 for information on ordering additional				L If all registered handsets start ringing in
handsets.
					step 2, press {x} to stop. Start again from
Important:					step 1.
L The additional handset model				L Charge the batteries of your additional
	recommended for use with this unit is				handset for about 7 hours before initial
	noted on page 5. If other model handset is				use.
	used, certain operations (handset			L This registration method cannot be used
	settings, base unit settings, etc.) may not				for handsets that have already been
	be available.				registered to the base unit. Register the
					handset manually (manual registration;
					page 28).
Registering a handset to
				To register a handset to the base unit
the base unit				(manual registration)
The included handset and base unit are				You can register a handset to the base unit
				manually using the following method.
preregistered. If for some reason the			1			{j/OK} i “Handset Setup” i
handset is not registered to the base unit (for
example, w flashes even when the handset					{>}
			2			“Registration” i {>}
is near the base unit), register the handset
manually (page 28).			3			“Register H.set” i {>}
				4 Press and hold {x} on the base unit for
To register an additional handset to the
						about 3 seconds, until the registration
base unit (easy registration)						tone sounds.
After purchasing an additional handset,						L If all registered handsets start ringing,
register it to the base unit. Ensure that the						press {x} to stop, then repeat this
additional handset is switched on. If it is not						step.
on, press and hold {ih} for few seconds						L After pressing {x}, the rest of this
to turn the handset on.
						procedure must be completed within 1
1 Lift the additional handset and press
						minute.
	{ih} to put the handset in standby		5			Wait until “Enter Base PIN” is
	mode.
2 Press and hold {x} on the base unit for						displayed, then enter the base unit PIN
						(default: “0000”), then press {j/OK}.
	about 3 seconds, until the registration					L If you forget your PIN, see page 35.
	tone sounds.
28		Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333