Panasonic MC-UL425 manuel dutilisation Lay unit on floor bottom up with nozzle flat

		Agitator
		Agitateur
		Agitador
		End Cap
Motor Shaft		Bouchon
		Tapa del
Arbre d’entrainement
du moteur	Belt	extremo
Eje del motor		Groove
	Courroie
	Correa	Rainure
		Ranura

➢Loop new belt (part number MC-V390B, Type UB12) around motor shaft and agitator belt groove. Make sure belt is routed in the belt guide as shown. See illustration for correct belt routing.

➢Reinstall agitator back into nozzle by placing end caps into grooves.

➢After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely.

2

1

➢Place the vacuum in the upright position standing on the handle. This will minimize wheel interference when installing nozzle bottom plate.

➢Reinstall nozzle cover by (1) aligning front edge of the cover with the nozzle and (2) rotating to installed position.

Four Screws

Quatre vis

Cuatro Tornillos

➢Lay unit on floor bottom up with nozzle flat.

➢Install the four screws to the nozzle cover.

➢Route nozzle hose to hose holder. Align nozzle hose bracket with retaining bracket on body and slide down unit it clicks into place.

➢Return the vacuum cleaner to the upright position before plugging into an electrical outlet.

- 46 -