Cleaning Agitator
Almacenaje de herramientas
Rangement des accessoires
➢Certains des accessoires peuvent être
déjà rangés sur l'aspirateur.
➢Placer le tuyau sur le porte-tuyau,
devant le manche.
➢Fixer le tube au tuyau en alignant les
deux (2) saillies du tube avec les fentes
en « J » du tuyau, faire glisser les
saillies dans les fentes, puis tourner
pour verrouiller.
➢Ranger le tube dans la fente centrale du
porte-accessoires en le tournant et le
glissant par-dessus le tuyau court pour
un bon raccordement.
➢Ranger la brosse à épousseter dans la
fente avant du porte-accessoires.
➢Ranger le suceur plat dans la fente
rectangulaire arrière du porte-
accessoires.
➢Se reporter à l’illustration de la section
« Nomenclature » pour le rangement
approprié des accessoires.
➢Es posible que ya se almacenen unas
herramientas en la aspiradora.
➢Coloque la manguera en la parte trasera
del soporte de manguera.
➢Para conectar el tubo a la manguera,
alinee las dos (2) lengüetas levantadas
en el tubo con las ranuras "J" en la
manguera.Mueva las lengüetas hacia
las ranuras, ruédelas para asegurar.
➢Coloque la manguera en la primera
ranura del soporte de herramientas,
girando y empujando hacia abajo en la
manguera corta para asegurar una
conexión buena.
➢Almacene el tubo con el cepillo para
polvo en el extremo superior en la
ranura posterior y redonda del soporte
de herramientas.
➢Coloque la herramienta para tapices en
la ranura posterior y rectangular del
soporte de herramientas.
➢Véase la sección de “Identificación de
piezas”para la ubicación de las
herramientas
- 17 -
➢➢When the bristles on the agitator are
worn so that they do not touch a card
held across the lower plate,the
brushes should be replaced.
➢➢Remove lower plate and agitator.
➢➢Remove the E-clip from agitator shaft
and end cap.
➢➢Do not bend agitator shaft or lose E-
clip or spacer.
➢➢Pull agitator shaft out of agitator body.
➢➢Pull,or pry out, agitator holder and
agitator pulley.
➢➢Push each brush out of agitator body
as shown.
➢➢Install new brushes by reversing
procedure.
➢➢Reinstall agitator holder and agitator
pulley completely.
➢➢Reinstall the agitator shaft,end cap
and E-clip.
➢➢See exploded view for correct
assembly of parts.
➢➢Position belt over agitator pulley on
the agitator.
➢➢Reinstall agitator and lower plate.
Card
Carte
Tarjeta
E-Clip
BrideenE
Sujetadorde E
AgitatorShaft
Arbred’entraînement
Ejedel agitador
RightEnd Cap
Bouchondroit
Tapadel extremo
derecho
AgitatorHolder
Supportde l'agitateur
Soportedel agitador