Replacing Belt
|
| + |
Rear Belt | + |
|
|
| |
Cover |
|
|
Couvre- |
|
|
courroie |
| Lift Agitator Up |
arrière | Front Belt | Soulever l’agitateur |
Cubierta | Cover | Unidad del agitador |
de la correa | ||
trasera | ||
avant | ||
| ||
| Front Belt | |
| Cover |
Motor Shaft |
| |
Arbre |
| |
d’entraînement |
| |
du moteur | Install New Belt | |
Eje del motor | ||
Poser la nouvelle courroie | ||
| ||
| Instalación de la correa | |
| + | |
+ |
| |
Groove | End Cap | |
Ouverture | ||
Ranura | Bouchon | |
| Tapa del extremo |
➢Replace belt whenever a burning rubber smell caused by excessive slippage occurs.
➢Remove lower plate.
➢Rotate rear belt cover open and remove front belt cover.
➢Remove agitator by carefully lifting out.
➢Remove worn or broken belt.
➢Clean agitator.
➢Loop new belt (Panasonic Type UB4 only) around motor shaft and agitator pulley; see illustration for correct belt routing.
➢Reinstall agitator back into nozzle housing grooves.
➢After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely.
➢Rotate rear belt cover closed and reinstall front belt cover.
➢Reinstall lower plate.
- 30 -
