
The oven causes interference | Some radio and TV interference might occur when you cook with the |
with my TV. | microwave oven. This interference is similar to the interference caused |
| by small appliances such as mixers, vacuums, hair dryer, etc. It does not |
| indicate a problem with your oven. |
|
|
The oven lights dim. | When cooking with a power other than P10 – P3, the oven must cycle to |
| obtain the lower power levels. The oven light will dim and clicking noises |
| can be heard when the oven cycles. |
|
|
Steam accumulates on the oven | During cooking, steam and warm air are given off from the food. Most of |
door and warm air comes from | the steam and warm air are removed from the oven by the air which |
the oven vents. | circulates in the oven cavity. However, some steam will condense on |
| cooler surfaces such as the oven door. This is normal. |
|
|
I accidentally ran my microwave | Running the oven empty for a short time will not damage the oven. |
oven without any food in it. | However, we do not recommend this to be done. |
|
|
The oven has an odor and | It is essential that your oven is cleaned regularly particularly after |
generates smoke when using | cooking. Any fat and grease that builds up on the ceiling and walls of the |
the Bake, Combination and | oven will begin to smoke if not cleaned. |
Broil function. |
|
PROBLEM
Oven will not turn on.
POSSIBLE CAUSE
The oven is not plugged in securely.
Circuit breaker or fuse is tripped or blown.
There is a problem with the outlet.
The door is not closed completely.
REMEDY
Remove plug from outlet, wait 10 seconds and
Reset circuit breaker or replace fuse.
Plug another appliance into the outlet to check if the outlet is working.
Close the oven door securely.
Maintenance
Oven will not start cooking.
The words “DEMO MODE” appear on the screen.
When the oven is turning on, there is noise coming from Ceramic Tray.
Start Button was not pressed | Press Start Button. |
after programming. |
|
Another program has already | Press Stop/Reset Button to |
been entered into the oven. | cancel the previous program and |
| program again. |
The program has not been | Program again according to the |
entered correctly. | Operating Instructions. |
Stop/Reset Button has been | Program oven again. |
pressed accidentally. |
|
Oven is set at Demo Mode.* | Press Micro Power Button once, |
| press Start Button 4 times and |
| press Stop/Reset Button 4 times |
| to turn off Demo Mode. |
Roller Ring and oven bottom are | Clean these parts according to |
dirty. | Care of Your Oven (see next |
| page). |
*DEMO MODE is designed for retail store display.
Cooking and other functions will not operate during Demo Mode.
If it seems there is a problem with the oven, contact an authorized Service Center.
25