Before requesting service
|
|
|
| GENERAL DISTORTIONS |
|
There is no audio output and |
| Check the connections. |
| ||
the sound is distorted: |
| Deactivate the Advanced Surround effect. |
| ||
|
|
|
| ||
The VCR display does not light up: | Verify that the AC mains lead is properly attached |
| |||
|
|
|
|
| |
The VCR display is on but the |
| There is an active timer programme. Press the TIMER button to deactivate it. |
| ||
unit does not respond to any input: |
|
|
| ||
|
|
|
|
|
|
|
|
| This is indicative of a malfunction. The digits following "H" or "F" depend on what state your player is in. |
| |
Error code "H | " or "F | " | Press [ /I ] to put the player into standby mode, then briefly unplug and |
| |
| Contact the aftersales service if this does not remove the problem. Please state the error code |
| |||
appears: |
|
|
| ||
|
|
|
|
| |
|
|
|
| displayed by the set. |
|
|
|
|
| ||
The picture is disturbed when searching: | This is a technical issue and not indicative of a malfunction. |
| |||
|
|
|
|
|
|
The screen outputs no picture: | Check the connections. |
| |||
| Verify that the correct video input of the TV set has been selected. |
| |||
|
|
|
| ||
|
|
|
|
|
|
|
|
| Go to the SETUP screen and check the "TV Aspect" setting in the Video menu. |
| |
The picture is cut off at its left | Check whether the player is directly plugged into the TV set's "AV IN (Scart)" or whether it is going |
| |||
or right edge: |
|
|
| through a video recorder between the two units. |
|
|
|
|
|
| |
|
|
| Check the Zoom setting (page 50). |
| |
|
|
|
|
|
|
|
|
| Check if the remote control is operating VCR1 or VCR2 (page 33). |
| |
The remote control unit does |
| Check the distance between the remote control unit and the VCR/DVD (max. 7 metres). |
| ||
not work properly: |
|
| Check the batteries in the remote control unit (page 7). |
| |
|
|
| Point the remote control unit straight at the remote control signal sensor on the front panel. |
| |
|
|
|
|
|
|
No messages are output to |
| Go to the SETUP screen and set Display menu option |
| ||
| Go to the DVD SETUP screen and change the “TV Aspect” setting in the VIDEO menu. |
| |||
the screen: |
|
|
| ||
|
| Open the VCR menu to modify the VCR OSD display |
| ||
|
|
|
|
58