Panasonic PT-DW5000UL manual Indication of lamp monitor

Indication of lamp monitor

This projector is equipped with 3 indicators to show when a lamp needs replacement or there is an abnormal internal temperature. These lamps flash or light up to indicate a problem.

Turn the power off and follow the steps below.

Power indicator

Lamp 2 monitor (LAMP 2)

Lamp 1 monitor (LAMP 1)

Temperature monitor (TEMP) indicator

Name of monitor	Lamp	Information		Checkpoint	Remedial measure
lamp	indication
			• Did you turn on the		• Wait about five minutes in the
			power when the		current status.
	Lighting in	Warm-up status	ambient temperature		• Install the unit in a location
			was low		having an ambient
	red
			(approx. 0 °C)?		temperature from 0 to 45 °C.
	(lamp unit
	ON)
		High temperature
Temperature					• Remove the object that is
		inside. (WARNING)
monitor			• Check if the		blocking the ventilation port.
					• Move the projector to a
			ventilation port is
TEMP					temperature of 0 to 45 ˚C and
	Blinking in		blocked.
					the humidity of 20 to 80 % (no
	red	The filter is clogged.	• Is the room air
					condensation).
	(1 time)		temperature too high?
					• Turn off the MAIN POWER
			• Is the air filter clogged		switch using the procedure on
	Blinking in	High temperature	with dust?
					page 24 and clean the air filter
	red	inside			(refer to page 42).
	(2 times)	(Standby condition)
	Blinking in				• Turn off the main power supply
		Cooling fan has			(MAIN POWER) switch in the
	red
		been stopped.			procedure shown on page 24
	(3 times)
					and consult the distributor.
			• Did you notice a		• This lamp monitor lights up
					when the lamp unit used hours
			“REPLACE LAMP”
		Indicates the time			have reached 1 300 hours
	Lighting in		message on the
		for replacing the			(3 800 hours when long life
	red		screen when turning
		lamp unit.			lamp units are used). Request
			on the projector
					the dealer to replace the lamp
Lamp monitor			power supply?
					unit.
LAMP1 LAMP2			• Did you turn the power		• Wait until the lamp has cooled
			back on immediately		off, and then turn on the
			after turning it off?		power.
	Blinking in	Error is detected in
			• Some error has
	red	the lamp or lamp	arisen in the lamp		• Turn off the MAIN POWER
	(3 times)	power.	circuit.		switch using the procedure on
			• Check for fluctuation		page 24 and consult the
			(or drop) in the source		dealer.
			voltage.

Attention • To solve any problems that the TEMP and LAMP monitor show, first turn the power off by following the steps on pages 23, 24.

•If the power indicator blinks in red (3 times), the projector has malfunctioned. Please consult your dealer.

41