13) Turn the lens hood clockwise to attach.

zzAligning the point position of the lens hood with the end (on the left) of the caution label attached to the projector body, turn the lens hood while pushing it until it clicks to overlap with the point position of the projector body.

&DXWLRQODEHO

3RLQWSRVLWLRQRIWKHSURMHFWRUERG\

0DNHVXUHWRDOLJQWKHSRLQW

SRVLWLRQRIWKHOHQVKRRG

/HQVKRRG

Attaching the lens

■■Notes on attaching ET-ELW03

When attaching ET-ELW03, use two types of light- shielding plates.

Follow the procedure on “Attaching the lens”

( page 26) to set the light-shielding plate-3, and then follow the procedure below to set the light- shielding plate-1.

Attention

zzSet the light-shielding plate with the <THIS SIDE BACK> side down.

1)Turn on the projector before setting the light-shielding plate-1, and move the projected image to the most upper left with the lens shift function.

Getting Started

Attention

zzConfirm that the lens hood is attached completely. If not attached completely, the lens may fall off, causing damage.

14) Check that the lens and light- shielding plate are set properly.

zzTurn on the projector. Operate the lens shift, zoom, and focus fully to check that the light- shielding plate is moved with the lens properly. If the light-shielding plate interferes with lens operations, set the light-shielding plate again.

Attention

zzDo not operate the projector with the light-shielding plate removed. Doing so may result in malfunction of the projector.

2)Turn off the projector

3)Insert the light-shielding plate-1 in the direction shown in the figure and set it

to encircle the lens.

zzSet the light-shielding plates with the convex side of the light-shielding plate-1 down.

Light-shielding plate-1

(In front of the light-shielding plate-3)

Light-shielding plate-3

ENGLISH - 29