Attaching the lens
Adjusting the focus
After setting up the projector, turn on the power, and then project the image on the screen. Adjust the position of the projector and the projected image.
Started Getting
1)Loosen the focus lock screw.
2)Rotate the lens to obtain the proper
focus on the center area of the screen.
zzWhen the distance between the projector and the screen is 1 m (39"), set the position of the focus lock screw to the ● mark (yellow allow) of the lens.
3)Tighten the focus lock screw.
4)If the proper focus is not observed on outer area of the screen, proceed further adjustment.
(i)Turn the focus ring counterclockwise to loosen.
(ii)Rotate the lens to obtain the proper focus on outer area of the screen.
(iii)Turn the focus ring clockwise to tighten.
•If the proper focus is not observed over the entire screen, repeat steps from the first.
mark 
1)Rotate (i) to adjust the zoom.
2)Rotate (ii) to obtain the proper focus on the center area of the screen.
(i)
(ii)
Focus ring
Focus lock screw
30 - ENGLISH