Attaching the lens
Attaching the lens hood strap
In order to prevent the lens hood from falling off, use the supplied strap to tie the projector and the lens hood.
Started Getting
1)Turn the lens hood counterclockwise to remove.
2)Remove the screw C.
Lens hood
3)Thread the lens hood strap through the hole of the lens hood.
5) Turn the lens hood clockwise to attach.
zzAligning the point position of the lens hood with the end (on the left) of the caution label attached to the projector body, turn the lens hood while pushing it until it clicks to overlap with the point position of the projector body.
Caution label
Point position of the projector 
body
Make sure to align the point position of the lens hood
/HQVKRRGVWUDS 7KUHDGWKHVWUDSKHUH
$GMXVWLQJWKHSRVLWLRQRIWKHPHWDOSDUWRIWKHOHQVKRRGVWUDS KHUHSXOOWKHOHQVKRRGVWUDSWRIL[
4)Align the screw hole with the lens hood strap and tighten the screw that was removed in Step 2) over the strap.
Lens hood strap
CAUTION
Do not pull the lens hood strap forcibly.
Doing so may deform this metal part and fail to attach the lens hood.
CAUTION
Pull out the lens hood strap outside of the lens hood.
Put the lens hood strap between the lens hood and the projector body to attach the lens hood.
32 - ENGLISH