Powering on the projector
Control panel | Remote control |
Power |
|
| button | Power <POWER |
|
| |||
| ||||
|
|
|
| ON> button |
Before turning on the power, remove the lens cover.
1) Connect the power plug to the outlet.
(AC 100 V - 240 V 50 Hz/60 Hz)
2) Press the |
| side of the main power |
|
switch to turn on the power.
zzAfter a moment, the standby indicator <STANDBY> will go on and the projector will enter the standby mode.
3) Press the power |
|
| button on the |
|
| ||
|
control panel or the power <POWER ON> button on the remote control.
zzAfter a moment, an image will be projected and the currently selected input signal and lamp status ( page 96) will be displayed for approximately four seconds.
Note
zzWhen [PIN code lock] ( page 79) has been set to [On] using [Security] in the [Setting] menu, enter your PIN code.
zzThe projector will make a noise when the lamp comes on, but this is not a malfunction.
zzDuring projection, the fan rotates, making a sound. The sound may change depending on the ambient temperature, and when the lamp is on, the sound may become loud.
zzIf the lamp is switched off and immediately on again, the newly projected image may wobble for a few moments. This is due to the lamp characteristics and is not a malfunction.
zzWhen [Direct on] ( page 78) of the [Setting] menu is set to [On], the power will be turned on as soon as you insert the power plug into the outlet or set the main power switch to the side.
zzWhen [Display] ( page 69) of the [Setting] menu is set to [On] and [Logo] ( page 76) is set to [Off], the countdown will be displayed but the opening display will not be displayed.
zzWhen [Display] ( page 69) of the [Setting] menu is set to [Off] or [Countdown off], projection will start as soon as the lamp comes on, regardless of [Logo select] ( page 76) setting.
Powering on/off
zzAfter turning on the power, notes on [Filter warning] and [Lamp replacement] may be displayed depending on the status of the projector. ( page 97)
Making adjustments and selections
It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
4) Press the <FOCUS> button to adjust the focus of the image roughly. ( page 46)
5) Press the <INPUT 1> to <INPUT 4> buttons on the remote control or the <INPUT> button on the control panel to select the input terminal. ( page 47)
6) Adjust the projection angle. ( page 35)
zzExtend the adjustable feet to adjust the projection angle.
7)Press the <LENS SHIFT> button to adjust the position of the image. ( page 45)
8)Press the <ZOOM> button to adjust the size of the image to fit the screen. ( page 46)
9)Press the <FOCUS> button again to adjust the focus.
10)Press the <ZOOM> button again to adjust the zoom and the size of the image to fit the screen.
Basic Operation
ENGLISH - 43