ProjectingProjecting
Check the external device connections ( page 36) and power cord connections ( page 41) and then turn on the power ( page 43) to start projection. Select the input signal and adjust the image.
Selecting the input signal
Select an input signal.
The images selected using the <INPUT> button on the control panel or the <INPUT 1> to <INPUT 4> buttons on the remote control are projected. ( page 47)
Attention
zzImages may not be projected properly depending on the connected device, DVD, video tape, etc. to be played. zzThe <INPUT> button on the control panel cannot be used to select input signals. The input signal for each
input terminal must be selected in advance using the [Input] menu. If you press the <INPUT> button without having correctly selected the input signal, the projector will not project the image correctly.
Adjusting the image
■■Adjusting the position of the lens
1) Press the <LENS SHIFT> button on the remote control or the control panel.
zz[Lens shift] is displayed on the screen for four seconds.
Lens shift
2) While the display appears, press ▲▼◀▶ to move the image horizontally and vertically.
zzAs you move the image, there is a certain position at which the arrows pointing up, down, left and right turn red. This position is the center for the lens.
zzAt positions of maximum shift, the arrows disappear.
zzThe projector stores the setting made using the lens shift function when the power is turned off. zzWhen the position of the image is shifted, the image may become a little darker.
* The figure below shows an example of when the standard lens is attached.
Moves the image up
approx. 50% of its height.
Moves the image | With the lens moved completely up | Moves the image |
left approx. 10% of | right approx. 10% | |
its width. |
| of its width. |
With the lens moved completely to | With the lens moved completely to |
the left | the right |
Moves the image down approx. 50% of its height.
With the lens moved completely down
Basic Operation
ENGLISH - 45