Panasonic PT-F200NTU manual Remote terminal, Lamp switching, Switching input Signals

Technical Information

REMOTE terminal

You can remotely operate the projector from the outside the Remote control range by connecting to the REMOTE terminal.

Pin assignments and signal names

Pin No.	Signal name	Contents
A	GND	Ground
B	POWER	POWER ON
C	INPUT SEL3	Select input signal 3
D		NC
E	INPUT SEL1	Select input signal 1
F	INPUT SEL2	Select input signal 2
G		Connect internally
H
I	ENABLE	Control by external contact

LAMP switching

Pin No.						Settings
B - A				Short			Open
Operation					On		Off
Switching input		signals
Pin No.					Settings
C - A	Open		Open		Short	Short	Short	Open
E - A	Open		Short		Open	Open	Short	Short
F - A	Open		Open		Short	Open	Open	Short
Input signal	COMPUTER1		COMPUTER2		COMPONENT	VIDEO	S-VIDEO	NETWORK
								(PT-F200NTU
								only)
NOTE:

•When pin A and pin I are short-circuited, the buttons on the projector’s control panel, POWER and INPUT SELECT buttons on the Remote control cannot be used. In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.

•While pin I is “Open”, do not short-circuit pin A, B, C, E and F. The projector would reject all the signals from the Remote control.

Appendix

ENGLISH - 47