Panasonic PT-F300NTE, PT-F300E manual Position menu

POSITION menu

Remote control Control panel

See “Navigating through the menu” on page 34. See “Main menu and Sub-menu” on page 32.

DOT CLOCK

If you have interference patterns of the projected image, which is sometimes referred to as moire or noise, you can minimize it by pressing I H to adjust the clock frequency. (Available with signals of RGB/DVI still only)

KEYSTONE

If the projector is aligned non-perpendicularly to the screen, or if the projection screen has an angled surface, you can correct keystone.

Image Operation

NOTE:

•If the projecting signal’s dot clock frequency is higher than 150 MHz, the adjustment may not make a difference.

•DOT CLOCK needs to be adjusted before adjusting the

CLOCK PHASE.

CLOCK PHASE

If you require further adjustment for the same reason as the DOT CLOCK adjustment, you can fine adjust the timing of the clock. Press I H to adjust. (Available with signals of RGB/DVI still only)

NOTE:

•You can correct the distortion ± 30 degrees from the plane. For a better quality image, installing the projector with a minimum of distortion is recommended.

•Some distortion may be retained for lens shift adjustment.

•The distortion of the main menu screen is not correctable.

•The result of the keystone correction will affect the aspect ratio and the size of the image.

SHIFT

You can move the projected image for fine adjustment. Press I H to move horizontally and F G vertically. (Not available with NETWORK signals)

SHIFT	H
	V

NOTE:

•If the projecting signal’s dot clock frequency is higher than 150 MHz, the adjustment may not make a difference.

OVER SCAN

If the 4 edges of an image is partly dropped, you can use this function to adjust and project it properly. (Not available with signals of NETWORK)

IShrink

H Enlarge

Settings

ENGLISH - 37