Panasonic PT-F300E Resetting the Remaining, Turn the projector upside down and place it gently

Care and Replacement

Replacement procedure

1.	Turn the projector upside down and place it gently		Resetting the REMAINING
	on a soft cloth.		FILTER
2.	Use a Phillips-head screwdriver to loosen 3 ACF
	cover fixing screws until the screws turn freely and	1.	Turn on the projector and display the FILTER
	remove the ACF cover.		COUNTER RESET in PROJECTOR SETUP.
		2.	Press the ENTER button for more than 3 seconds.
			The confirmation screen will be displayed.

ACF cover fixing screw

3.Select OK by pressing I, then press the ENTER button.

4.Display the STATUS and confirm the figure.

Soft cloth

ACF cover

FILTER COUNTER RESET

RESET FILTER COUNTER?

3.Release the lock by pushing in the lock clamp to inside, and slide out the ACF unit from the projector slowly.

4.Insert the new ACF unit into the compartment in correct direction and slightly push down until it clicks. Tighten an ACF fixing screw securely with a Phillips-head screwdriver.

5.Attach the ACF cover and tighten the ACF cover fixing screws securely with a Phillips-head screwdriver.

Push in ACF

OK	CANCEL
	RETURN
SELECT
	ENTER

Maintenance

Push in Clamp

NOTE:

•If the ACF and/or ACF cover are attached incorrectly, the projector may not be turned on.

•Do not switch the power on while the ACF cover removed.

•When you replace the ACF unit, clean the compartment and/or the air exhaust port if you need to.

•The replacement timing of the ACF is 36 000 hours of use at maximum and it depends on environment of usage.

ENGLISH - 52