<System format selection for S-VIDEO (VIDEO) input signals>
If
Setting procedure
1.Press the MENU button to display the MENU screen.
2.Press the “ ” and “ ” buttons to select “PICTURE”.
3.Press the “<” and “>” buttons to display the PICTURE screen.
4.Press the “ ” and “ ” buttons to select
5.Press the “<” and “>” buttons to select either “AUTO”, “NTSC”, “PAL”, “SECAM” or “NTSC 4.43”.
Select the appropriate signal format for the input signal while referring to the table below.
Horizontal scanning frequency [kHz] Vertical scanning frequency [Hz] Color subcarrier frequency [MHz]
AUTO | Automatically selects NTSC, PAL, SECAM or NTSC 4.43. |
NTSC | 3.58 |
15.7 | 60.00 |
NTSC 4.43 | 4.43 |
PAL | 4.43 |
15.63 | 50.00 |
SECAM | 4.25 or 4.41 |
NOTE:
The correct signal format may not be selected if, for instance, you are using a
The setting screen and the MENU screen can both be cleared by pressing the MENU button.
Adjusting the volume
The volume can be adjusted by pressing the VOL
If the “+” button is pressed, the volume will increase,
Remote control unitand if the
NOTE:
If these buttons are pressed while the
The volume can also be adjusted from an
The volume output level will remain displayed on the screen for approximately three seconds.
