Option settings
Press the F or G button on the projector or remote control unit to select an item, then press the I or
Hbutton to change the setting.
|
| OPTION | ||
OSD |
|
|
| ON |
AUTO | SEARCH | ON | ||
AUTO | SIGNAL | ON | ||
AUTO | KEYSTN | ON | ||
RGB2 | SELECT | INPUT | ||
RGB/YPB PR | AUTO | |||
VGA60/480p | 480p | |||
SXGA | MODE | SXGA | ||
NR |
|
|
| OFF |
BLACKBOARD | OFF | |||
|
|
|
| ▼ |
SELECT |
| ADJ | RETRN | |
| ||||
|
|
|
| |
|
| OPTION | ||
|
|
|
| ▲ |
BACK | COLOR | BLUE | ||
|
|
|
|
|
FRONT/REAR | FRONT | |||
|
|
|
|
|
DESK/CEILING | DESK | |||
|
|
|
| |
FAN | CONTROL | STANDARD | ||
|
|
|
|
|
LAMP | POWER | HIGH | ||
LAMP | RUNTIME | 10H | ||
|
|
|
|
|
FUNC | 1 |
|
| DAYLIGHT |
|
|
|
| |
CONTROL | KEY | ON | ||
|
| |||
AUTO POW.OFF DISABLE | ||||
|
|
| ||
|
|
| ||
POWER MEMORY | ON | |||
SELECT |
| ADJ | RETRN | |
OSD
ON
The signal name is displayed in the
OFF
Use this setting when you do not want the signal name to be displayed.
NOTE:
BThe setting for
AUTO SEARCH
This should normally be set to “ON”
ON
When the power is turned on and “AUTO SETUP” is running, the projector detects which signals are being input, and uses these signals for projection.
(If a picture is being projected, the signal source is not automatically changed.)
OFF
Use this setting when you do not want the signal source to be changed automatically when the power is turned on and “AUTO SETUP” is running.
AUTO SIGNAL
This should normally be set to “ON”.
ON
“AUTO SETUP” will be carried out automatically when the input signal is changed.
OFF
“AUTO SETUP” will not function when the input signal is changed.
AUTO KEYSTN
This should normally be set to “ON”.
ON
During “AUTO SETUP”, the angle of tilt of the projector is detected and keystone distortion is corrected automatically.
OFF
Use this setting when you do not want automatic keystone correction to be carried out during “AUTO SETUP”, such as when the screen itself is at an angle.
