Important Safeguards and Precautions
READ AND RETAIN ALL SAFETY AND
OUTDOOR ANTENNA INSTALLATION
OPERATING INSTRUCTIONS.HEED ALL
WARNINGS INTHE MANUAL AND ON UNIT
INSTALLATION
1 POWER SOURCE CAUTION
Operate only from power source indicated on unit or in this manual. If uncertain, have your Electric Utility Service Company or Video Products Dealer verify your home power source.
2 POWER CORD PLUG
For safety, this unit has a polarized type plug (one wide blade), or a
1 SAFE ANTENNA AND CABLE CONNECTION
An outside antenna or cable system must be properly grounded to provide some protection
against built up static charges and voltage. Section 810 of the National Electrical Code, ANSI/NFPA 70 (in Canada, part 1 of the Canadian Electrical Code) provides information regarding proper
grounding of the mast and supporting structure, grounding of the
ANTENNA LEAD
IN WIRE
GROUND | ANTENNA |
DISCHARGE UNIT | |
CLAMP | (NEC SECTION |
GROUNDING
CONDUCTORS
(NEC SECTION
GROUND CLAMPS
POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H)
AC power cord. Regularly remove dust, dirt, etc. on the plug.
POLARIZED PLUG CA | UTION: |
The plug fits into outlet one way. If it cannot be fully inserted, try reversing it. If it still will not fit, have an electrician install the proper wall outlet. Do not
tamper with the plug.
2KEEP ANTENNA CLEAR OF HIGH VOLTAGE POWER LINES OR CIRCUITS
Locate an outside antenna system well away from power
lines and electric light or power circuits so it will never touch these power sources should it ever fall. When installing antenna, absolutely never touch power lines, circuits or
other power sources as this could be fatal.
GR OUNDING PLUG CA | UTION: |
The plug requires a
3POWER CORD
To avoid unit malfunction, and to protect against electrical shock, fire or personal injury:
plug (polarized or grounding) and must be securely connected.
-Overloaded wall outlets or extension cords is a fire hazard.
4 DO NOT BLOCK VENTILATION HOLES
Ventilation openings in the cabinet release heat generated during operation. If blocked, heat
For your protection:
a. Never cover ventilation slots while unit is ON, or operate unit while placed on a bed, sofa, rug, or other soft surface.
b. Avoid
5AVOID EXTREMELY HOT LOCATIONS OR SUDDENTEMPERATURE CHANGES
Do not place unit over or near a heater or
regulator, in direct sunlight, etc. If unit is suddenly moved from a cold place to a warm place,
moisture may condense in unit and on the tape causing damage.
6TO AVOID PERSONAL INJURY
•Never place unit on support or stand that is not firm, level, and adequately strong.
The unit could fall causing serious injury to a child or adult and damage to the unit.
•Move any appliance and cart combination with care. Quick stops, excessive force, and uneven surfaces may cause objects to overturn.
•Carefully follow all operating instructions.
USING THE UNIT
Before unit is brought out of storage or moved to a new location, refer again to the INSTALLATION section of these safeguards.
1KEEP UNIT WELL AWAY FROM WATER OR
MOISTURE, such as vases, sinks, tubs, etc.
2IF EXPOSED TO RAIN, MOISTURE, OR STRONG
IMPACT, unplug unit and have it inspected by a qualified service technician before use.
3ELECTRICAL STORMS
During a lightning storm, or before leaving unit unused for extended periods of time, disconnect all equipment from the power source as well as the antenna and cable system.
4WHEN UNIT IS PLUGGED IN
•DO NOT OPERATE IF: - liquid has spilled into unit.
- unit was dropped or otherwise damaged. - unit emits smoke, malodors, or noises.
Immediately unplug unit, and have it inspected by a service technician to avoid potential fire and shock hazards.
•Never drop or push any object through openings in unit. Touching internal parts may cause electric shock or fire hazard.
•Keep magnetic objects, such as speakers, away from unit to avoid electrical interference.
5 USING ACCESSORIES
Use only accessories recommended by the manufacturer to avoid risk of fire, shock, or other hazards.
6 CLEANING UNIT
Unplug unit. Use a clean, dry, chemically untreated cloth to gently remove dust or debris. DO NOT USE cleaning fluids, aerosols, or forced air that could
SERVICE
1 DO NOT SERVICE PRODUCT YOURSELF
If, after carefully following detailed operating instructions, the unit does not operate properly, do not attempt to open or
remove covers, or make any adjustments not described in the manual. Unplug unit and contact a qualified service technician.
2 REPLACEMENT OF PARTS
Make sure the service technician uses only parts specified by the manufacturer, or have equal safety characteristics as original parts. The use of unauthorized substitutes may result in fire, electric shock, or other hazards.
3 SAFETY CHECK AFTER SERVICING
After unit is serviced or repaired, request that a through safety check be done as described in the manufacturer’s service literature to insure video unit is in safe operating condition.
2
