Initial Setup (Ready to Play)
Please make all cable or antenna connections before powering on.
Connections
For ANT./Cable
Connect the cable from Antenna/Cable to the VHF/UHF terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on your cable box to the VHF/UHF terminal on the unit with a RF cable.
WARNING
Overtightening “Nut type” RF coaxial cables may damage jacks. Finger tighten only.
VHF/UHF | IN from |
| ANT./CABLE |
VHF/UHF |
|
Cable TV
Converter Box
| IN from |
VHF/UHF | ANT./CABLE |
VHF/UHF
Initial Setup (Ready to Play)
Plug the unit power cord into an AC
1 wall outlet.
Press POWER* on the remote or unit.
2 The unit comes on and auto channel and clock set starts.
CH AUTO SET PROCEEDING | AUTO CLOCK SET |
PROCEEDING
CANCEL : PRESS STOP KEY
•If you use a cable box, turn it on and set it to the Public Broadcasting Service (PBS) channel in your time zone. If you use a DSS receiver, it must be turned off.
Settings are made automatically. When
3 setup is done, this screen appears.
2/ 6/2003 THU 12: 00PM
DST : ON
SETT I NG : CH 10
AUTO CLOCK SET
COMPLETED
If AUTO CLOCK SET IS INCOMPLETE screen appears, set the clock using MANUAL CLOCK SET procedure on next page.
AUTO CLOCK SET
I S I NCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACT I ON KEY
Notes
•Function buttons are inoperative during Initial Setup.
•Depending on conditions, Auto Clock Set may take longer than 30 minutes. If so, press STOP to stop setup and perform settings manually. (See page
10 | For assistance, please call : |
