Connections
Output side connections
Connect the various equipment to the DJ mixer using stereo connection cables, connection cables and appropriate cables (Each sold separately). When connecting, make sure to turn all equipment power off.
Stereo connection cables | White (L) | |
Red (R) | ||
| ||
Speakers | Speakers | |
(Not included) | (Not included) |
Amplifier | Amplifier |
(Not included) | (Not included) |
Speakers |
(Not included) |
Monitor amplifier |
(Not included) |
Connect when using an amplifier that has XLR terminals. Terminal polarity is indicated in the diagram below.
Ground Hot (+)
Cold
Rear panel
Amplifier
(Not included) (XLR terminal compatible)
Speakers
(Not included)
Connection cable
(Not included)
Type:
RCA coaxial
AV Control Receiver
(Not included)
Cassette deck (Not included)
Type:
6.3 mm (1/4 in.) monaural
Effector (Not included)
Connect if you want to use an external effector or sampler etc. to adjust the sound.
Front panel
Connection to the XLR terminals
•Open the terminal cover, align the polarities on the XLR plug (not included) and XLR terminal and insert the plug until it locks.
•To remove the XLR plug, press the knob on the top of the plug and remove it.
•After removing it, press the center of the terminal cover and close firmly.
When using a monaural input effector
Type:
6.3mm (1/4 in.) stereo
Headphone
•Connect to the R/MONO terminal.
•The mixed left (L) and right (R) signal is output to the effector, and the left (L) and right (R) signal from the effector is input.
(Not included)
When listening with headphones
•Turn down the volume using the MONITOR LEVEL control knob before connecting.
•Avoid listening for prolonged periods of time to prevent hearing damage.
7
RQT7230