Panasonic RQT7230-3Y, SH-MZ1200 Using the microphone, Recording and playing on external equipment

Mixing (Basic operations)

OUTPUT

LEVEL meter

Changing the channel fader, cross fader operation method

Use the channel fader switch to change the operation method for each channel.

(e.g. using CH1) Switch [CH1 FADER] and [CROSS FADER] NORMAL: Operation is as indicated on the panel REVERSE: Operation is reverse as indicated on the panel

Changing the cross fader curve

Select from 1 of 3 types of cross fader startup curves. Switch [CURVE]

Output level meter display

•The mixed left (L) and right (R) volume level of the selected channel (CH1-CH4) is displayed in the LEFT and RIGHT columns of the output level meter.

Display range: –20 to +8 dB

•Even if the MASTER LEVEL or MASTER BALANCE is changed the OUTPUT LEVEL meter display does not change.

Using the microphone

Turn [MIC LEVEL], [HIGH] and [LOW] to adjust volume and sound

Adjusts the microphone volume and sound connected to MIC 1 and MIC 2 terminals.

MIC LEVEL:

Adjusts the microphone volume (Attenuation: – ∞ to 0 dB)

HIGH:

Adjusts the high tone microphone sound. Sound is flat at the center position.

Turn to the right to increase (to approximately +12 dB at 10 kHz) Turn to the left to decrease (to approximately –24 dB at 10 kHz)

LOW:

Adjusts the low tone microphone sound. Sound is flat at the center position.

Turn to the right to increase (to approximately +12 dB at 100 Hz) Turn to the left to decrease (to approximately –24 dB at 100 Hz)

•Input of MIC 1 and MIC 2 is mixed and output through the MASTER OUT 1 left (L) and right (R) terminals.

Recording and playing on external equipment

You can record and play on externally connected equipment.

Using the REC OUT terminal

The same source as MASTER OUT 1 is output.

Using the DIGITAL OUT terminal

The same digital signal source as MASTER OUT 1 is output.

Even if the MASTER LEVEL or the MASTER BALANCE is changed the REC OUT or DIGITAL OUT output does not change and recording or play remains unaffected.

Note

The channel fader and cross fader used with this unit are designed for extended use however, depending on the way they are being used (e.g. quick, repetitive movements such as Hip Hop transfer play,etc.) replacement may be necessary.

•Contact your nearest dealer to have your channel fader and or cross fader replaced.

•To the dealer:

The “Fader Replacement Instructions” are included with the

replacement product.

Replacement part number

Channel fader (Part No. REP3743A-S)

Cross fader (Part No. REP3742A-S)

10

RQT7230