Power sources
The unit can be powered with household AC power or dry cell batteries (not included).
Insert memory batteries (not included) to save the current time, stored timer settings and radio stations.
Using a household AC outlet
Connect the AC power supply cord firmly to the unit and the outlet.
Household AC outlet |
(AC 120 V, 60 Hz) |
AC power cord |
(included) |
Note |
The included AC power supply cord is for use with this unit only. Do not use it with other equipment.
Using batteries (not included)
The unit cannot be powered by batteries if the AC power supply cord is connected.
(R14/LR14, C, | Inner row |
| Outer row |
When to change the batteries
When the battery indicator begins flashing, replace all 6 of the batteries. It is also a good idea to replace all the batteries before recording.
Note
Before playing starts the battery indicator may flash although the batteries are not drained. It appears correctly once you start play.
Memory back-up
Insert batteries (not included) to save the current time, timer settings and radio stations you have set. If memory batteries are not used, memory items are erased in the following situations:
•Power failures,
•The AC power supply cord is disconnected from the power outlet,
•The AC power supply cord is connected to the
unit while the unit is being powered by batteries. These batteries do not power the unit.
(R6/LR6, AA,
When to change the batteries The batteries last about a year.
Connect the unit to AC power before replacing the batteries.
Before connecting or disconnecting the AC power supply cord, press [TAPE/OFF] and stop the tape to turn the unit off. The memory batteries are worn out faster if the cord is disconnected with the power still on.
Removing the batteries
Open the battery cover and insert your finger in the hole on the bottom of the unit and push out. (Remove the power batteries first.)
For R14/LR14, C,
For R6/LR6, AA, |
Concerning the remote control
Battery installation
Insert the batteries (not included) observing the correct polarities (
,
).
(R6, AA,
1
1
Correct method of use
2
2
About 7 meters in front of the signal sensor
Remote control signal sensor
Transmission window
Operation notes
• Do not place obstacles between the remote control signal sensor and the remote control unit.
• Do not expose the remote control signal sensor to direct sunlight or to the bright light of fluorescent light.
• Take care to keep the remote control signal sensor and end of the remote control unit free from dust.
To prevent damage
• Never place heavy items on it.
• Do not disassemble or reconstruct it.
• Do not spill water or other liquids into it.
4
RQTT0585
