Panasonic RX-D29 operating instructions Listening to CDs, Normal play, Program play, CD play modes

To pause

To search forward/ backward

To skip forward/ backward

To stop play Press [ ].

While stopped, the number of tracks on the CD is displayed.

Adjust the volume.

RX-D29only

When playing MP3, “MP3” is displayed.

4

Track number in play

Listening to CDs

Normal play

3 12 4

1	Push [	CD OPEN/CLOSE] to
	open the CD lid and insert the CD.
	Label must face upward.
	Push [	CD OPEN/CLOSE] to
2 close the CD lid.
3	Press [CD	/ ] to start play.	Elapsed play time
	(Unit comes on.)
	Play starts from the first track and
	continues to the last track.

	(MP3 only)
Total playing time	Total number of tracks

Total number of tracks Total number of albums

Press [CD / ] during playback.

To resume, press [CD / ].

Hold down [−/ ] (backward) or [ /+] (forward) during playback or when paused.

You cannot search while playing MP3.

Press [−/ ] (backward) or [ /+] (forward) during playback or when paused.

Display

“NO DISC” is displayed if there is no disc in the unit.

Note

•If interference occurs to radios or televisions, place the unit as far as possible from the equipment.

• Do not push [ CD OPEN/CLOSE] during play, pause or immediately after you inserted the CD and closed the CD lid. CD may be scratched.

This unit can play CD-DA (digital audio) format audio CD-R and CD- RW that have been finalized (a process that enables CD-R/CD-RW players to play audio CD-R and CD-RW) upon completion of recording. It may not be able to play some CD-R or CD-RW due to the condition of the recording.

Program play

You can program up to 24 tracks.

2

1 3

Remote control only

Ensure CD is stopped before programming.

1 Press [PGM/CLEAR].

2 Enter the track number with the numbered buttons.

To select a two digit number

e.g.16: [>10] → [1] → [6]

=

To select a three digit number (MP3 only)

e.g.226: [>10] → [>10] → [2] → [2] → [6]

==

Program order	(MP3 only)
	Program order
Specified track number
	Specified track number

Total play time of programmed tracks

Repeat step 2 until you have programmed all the tracks you want.

3 Press [CD / ] .

To cancel program play mode

Press [PGM/CLEAR] while stopped. “CLEAR” is displayed.

The mode is also canceled if the CD tray is opened.

This will also erase the entire program.

To check program contents

“P” appears in the display when play is stopped. Press [–/ ] or [ /+] when “P” is displayed.

To check while programming press [DISPLAY] twice and after “P” appears, press [–/ ] or [ /+].

Display

“— —:— —”: Program equals, or exceeds, 100 minutes but

	programming and play are still possible.
“FULL”:	24 tracks have already been programmed. The program is full.

CD play modes

Remote control only

You can repeat one track ( ), all tracks ( ) or play the tracks in

random order ( ).

Press [PLAY MODE] before or during playback to select the desired mode.

off (no indication)

RX-D29 only

When playing MP3, see page 8.

These modes remain active until the indicators are cleared.

You can use repeat mode with program play.

Note

•During play, you cannot select random play.

•Random and program play cannot be performed at the same time.

7

RQTT0585