Panasonic SA-XR30 Settings, Setup, Complete, Speakers, Distance, Filter, D- Input, In Mode

Step 3 Settings

Setup

Change the settings to suit your equipment to the environment in which you are using it. Before making any changes, read the descriptions of the settings, note the factory settings and ranges, and refer to the equipment’s instructions.

^

POWER 8

Switch on.

-HELP

SPEAKERS -RESET

	Display		INPUT SELECTOR
	INPUT SELECTOR	VOLUME
	-HELP
SPEAKERS	-RESET
POWER 8
		DOWN	UP

PHONES

Step 3

RQT7512

8

1	Enter the setup
	mode.

-HELP

SPEAKERS -RESET

Press and hold at the same time

SETUP

(Setup menus and factory settings á page 21)

Change the

2 settings.

To finish settings

-HELP

SPEAKERS -RESET

Press and hold at the same time

COMPLETE

SPEAKERS

Set the size to suit your speakers.

LARGE: For speakers that can reproduce a full sound range, particularly the bass range below 100 Hz.

SMALL: For speakers that cannot adequately reproduce the bass range. This setting is sufficient for most speakers if you are using a subwoofer.

NONE: For speakers you haven’t connected (center or surround).

For the subwoofer (SUB-WFR), select YES if you have connected one, or NO if you have not.

DISTANCE

Enter the distance of the front, center and surround speakers from the seating position.

By setting the distance between the speaker’s position (except the subwoofer) and the listener’s seating position, the sound delay time is automatically adjusted so that sound reaches the listener at the same time. You can select distances between 3 and 30 feet at one-foot intervals.

FILTER

Change the cut-off for bass output from the front speakers. If you set the front speakers to “SMALL”, the filter is set to

100 Hz. Raise the cut-off if the bass from the front speakers is unsatisfactory so that this bass is output through the subwoofer. You can raise the cut-off from 100 Hz to either 150 Hz or 200 Hz.

D-INPUT (Digital input)

Change these settings to suit the connections you have made to the optical (OPT) and coaxial (COAX) digital input terminals, so that the correct source is selected when you turn [INPUT SELECTOR].

IN MODE (Input mode)

This unit automatically detects whether input is digital or analog, but you can fix the input mode.

AUTO: Automatically detects the input signal and plays

ANALOG: Fixes the input signal to analog and plays

DIGITAL: Fixes the input signal to digital and plays

PCM FIX: Fixes the input signal to PCM and plays

1. Select.

-HELP

SPEAKERS -RESET

SPEAKERS

1. Select.

-HELP

SPEAKERS -RESET

DISTANCE

1. Select.

-HELP

SPEAKERS -RESET

FILTER

1. Select.

-HELP

SPEAKERS -RESET

D- INPUT

1. Select.

-HELP

SPEAKERS -RESET

IN MODE