Panasonic SC-AK640 important safety instructions Radio, Manual tuning, Memory preset

Press [PLAY MODE] to select “MANUAL”.

Radio

ENGLISH

Numeric

buttons DANSK

Manual tuning

FRANÇAIS	1	Press [TUNER, BAND] to select “FM” or “AM”.
	2	Press [PLAY MODE] to select “MANUAL”.
	3	Press [4, REW / ] or [¢,		/ FF] to select the
		frequency of the required station.
		• “	” is displayed when a stereo FM broadcast is being
		received.
		• “TUNED” is displayed when a radio station is tuned.
	To tune automatically
	Press and hold [4, REW / ] or			[¢,	/ FF] until the
	frequency starts changing rapidly. The unit begins auto
	tuning, stopping when it fi nds a station.
	•	Auto tuning may be interrupted when there is excessive
- 4		interference.
	•	To cancel auto tuning, press [4, REW /			] or
LANG		[¢,	/ FF] once again.
	To improve FM sound quality

Press and hold [PLAY MODE] to display “MONO”.

To cancel

Press and hold [PLAY MODE] again until “MONO” disappear.

•MONO is also canceled if the frequency is changed.

•Turn off “MONO” for normal listening.

LANG - 5

RQTV0071

12

FM allocation setting

By main unit only

This system can also receive FM broadcasts allocated in 0.1 MHz steps.

To change the step to 0.1 MHz

1 Press and hold [TUNER, BAND].

After a few seconds the display changes to a fl ashing display of the current minimum frequency.

2 Continue to hold down [TUNER, BAND].

•When the minimum frequency changes, release the button. To return to the original step, repeat the above steps.

•After changing the setting, previously preset frequency will be cleared.

Memory preset

Up to 15 stations each can be set in the FM and AM bands.

Preparation

Press [TUNER, BAND] to select “FM” or “AM”.

Automatic presetting

1	Tune to the frequency where pre-setting is to begin.
2	Press and hold [PROGRAM] to start presetting.

The tuner presets all the stations it can receive into the channels in ascending order. When fi nished, the last station memorized is tuned in.

Manual presetting

1

2	Press [4, REW / ] or [¢, / FF] to tune to the
	required station.
3	Press [PROGRAM].
4	Press the numeric buttons to select a channel.
	For channels 10 to 15 press [h10], then the two digits.

The station occupying a channel is erased if another station is preset in that channel.

Selecting a preset station

Press the numeric buttons to select the channel.

OR
1	Press [PLAY MODE] to select “PRESET”.
2	Press [4, REW / ] or [¢, / FF] to select the
	channel.

RQT8043