Panasonic SC-EN53 The radio manual tuning, The radio preset tuning, Manual pre-setting, Play Mode

The radio: manual tuning

		CLOCK	TIMER
		TIMER ADJ	ON/OFF
	DISPLAY	SLEEP	PGM/–CLEAR
PLAY MODE	EQ	LIVE VIRTUALIZER PLAY MODE
1	AUX	TUNER/BAND CD

TUNING MODE

The radio: preset tuning

Up to 12 stations each can be set in the FM and AM bands.

Preparation:

Press [TUNER/BAND] to select “FM” or “AM”.

CLOCK	TIMER
TIMER ADJ ON/OFF
DISPLAY SLEEP	PGM/–CLEAR
		PGM/–CLEAR

3

4

2

VOLUME

EQ	LIVE VIRTUALIZER PLAY MODE
AUX	TUNER/BAND CD
TUNING MODE
2			g/∂, µ/f
		VOLUME
3

1Press [TUNER/BAND] to select “FM” or “AM”.

The unit comes on.

Every time you press the button: FM ↔ AM

2Press [TUNING MODE] to select “MANUAL”.

Every time you press the button:

MANUAL ↔ PRESET

3Press [g/∂] or [µ/ f] to select the frequency of the required station.

4Adjust the volume.

Auto tuning

Press and hold [g/∂] or [µ/f] for a moment until the frquency

starts changing rapidly. The unit begins auto tuning, stopping when it finds a station.

•Auto tuning may not function when there is excessive interference.

•To cancel auto tuning, press [g/∂] or [µ/f] once again.

To improve reception

Extend the whip antenna and adjust its direction.

If noise is excessive in FM

Remote control only

Press [PLAY MODE] to display “MONO”.

This mode improves sound quality if reception is weak, but broadcasts will be heard in monaural.

Press [PLAY MODE] again to cancel the mode.

“MONO” goes out. MONO is also cancelled if the frequency is changed.

Turn off “MONO” for normal listening. Stereo and monaural broad-

casts are automatically played as they are received.

FM allocation setting

Main unit only

By adjusting the allocation, you can enable this tuner to receive FM

broadcasts allocated in 0.1 MHz steps.

Preparation:

Press [TUNER/BAND] to select “AM”.

Press and hold [TUNER/BAND]. After a few seconds, the display will change to a flashing display of the current minimum FM frequency. If you continue to hold the button down, the minimum frequency will change. Release the button at this time.

To return to the original frequency indication, repeat above.

Note

•After changing the “allocation” setting, the frequencies you previously preset in the memory will be cleared.

10

1

Manual pre-setting

Remote control only

Pre-set the stations one at a time.

1Press [PGM/–CLEAR] then press [g/∂] or [µ/ f] to tune to the required station.

2Press [PGM/–CLEAR] then press [g/∂] or [µ/ f] to select a channel.

3Press [PGM/–CLEAR].

The station occupying a channel is erased if another station is preset in that channel.

Selecting channels

1Press [TUNING MODE] to select “PRESET”.

2Press [g/∂] or [µ/f] to select the channel.

3Adjust the volume.

RQT6734