11
RQT9743
Preparation
≥Turn the unit on.
≥A station previously stored is overwritten when another
station is stored in the same channel preset.
1Press [PLAY MENU] to select “A.PRESET”.
2Press [3,4] to select “LOWEST” or “CURRENT”
and then press [OK].
LOWEST:
CURRENT:
To begin auto preset with the current frequency.*
* To change the frequency, refer to “Manual tuning and
presetting”.
The tuner starts to preset all the stations it can
receive into the channels in ascending order.
Preparation
1Press [PLAY MENU] repeatedly to select
“TUNEMODE”.
2Press [3,4] to select “PRESET” and then press
[OK].
Press [:/6] or [5/9] to select the channel.
∫Manual tuning and presetting
Select a radio broadcast.
1Press [PLAY MENU] repeatedly to select
“TUNEMODE”.
2Press [3,4] to select “MANUAL” and then press
[OK].
3Press [:/6] or [5/9] to tune to the
required station.
≥To start automatic tuning, press and hold [:/6],
[5/9] until the frequency starts scrolling. Tuning
stops when a station is found.
To preset the channel
4While listening to the radio broadcast
Press [OK].
5Press [3,4] to select the channel and then press
[OK].
∫To improve FM sound quality
1While receiving FM broadcasts, press
[PLAY MENU] repeatedly to select “FM MODE”.
2Press [3,4] to select “MONO” and then press
[OK].
≥This setting can be preset and memorised. To do so,
continue to step 4 of “Manual tuning and presetting”.
≥Select “STEREO” in step 2 to return to stereo broadcasts.
≥“MONO” is cancelled if the frequency is changed.
≥“STEREO” is displayed when this unit tunes to a stereo
broadcast.
Listening to FM/AM radio
AM radio is only available for [SC-HC38]
([Australia[and[New[Zealand[ only).
You can preset up to 30 FM channels / 15 AM
channels.
≥Make sure that the antenna(s) are connected. (l5)
≥Press [RADIO] to select “FM” or “AM”.
Presetting stations automatically
To begin auto preset with the lowest frequency
(FM 87.50, AM 520 or AM 522).
Listening to a preset channel
≥If “MONO” is selected, regardless of the type of signal this
unit is receiving, “FM MONO” is displayed. (lbelow)
∫To display the current FM signal status
While receiving FM broadcast, press [DISPLAY].
“FM ST”: The FM signal is in stereo.
“FM”: The FM signal is in monaural.
≥“FM” is also displayed even if this unit is not tuned to a
station.
SC-HC38_DBEB_DBGN_GS~RQT9743-B.book 11 ページ ２０１３年１月２１日 月曜日 午後１時６分