13
RQT9743

Others

As a factory preset, this unit will always turn off
automatically if there is no sound output and no
operation for approx. 30 minutes.
To cancel this function
1Press [SETUP] repeatedly to select “AUTO OFF”.
2Press [3,4] to select “OFF” and then press [OK].
To turn automatic standby on, select “ON” in step 2.
The brightness of this unit’s display can be changed.
1Press [SETUP] repeatedly to select “DIMMER”.
2Press [3,4] to select “ON” and then press [OK].
To cancel the dimmer, select “OFF” in step 2.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1Press [CD] to select “CD”.
2While pressing and holding [SELECTOR] on the
unit, press and hold [CD/RADIO] on the remote
control until the unit's display shows “REMOTE 2”.
3Press and hold [OK] and [CD/RADIO] on the
remote control for at least 4 seconds.
To change the mode back to “REMOTE 1”, repeat the steps
above but replace the button pressed on the remote control
from [CD/RADIO] to [ ].

Troubleshooting

Before requesting service, make the following checks.
If you are in doubt about some of the check points, or if
the solutions indicated in the following guide do not
solve the problem, consult your dealer for instructions.
Humming heard during play.
An AC mains lead or fluorescent light is near the cords. Keep
other appliances and cords away from this unit’s cables.
MP3 cannot be read.
You may not be able to play MP3 if you have copied a
multi-session disc that has no data between sessions.
When creating a multi-session disc, it is necessary to close the
session.
The amount of data on the disc is too small. Set the amount of
data to above 5 MB.
Incorrect display or play will not start.
Make sure that the disc is compatible with this unit. (l16)
There is moisture on the lens. Wait for about an hour and then try
again.
No response when [1/;] is pressed.
Disconnect the USB device and then reconnect it. Alternatively,
turn the unit off and on again.
The USB drive or its contents cannot be read.
The USB drive format or its contents is/are not compatible with the
unit (l16).
The USB host function of this product may not work with some
USB devices.
Slow operation of the USB flash drive.
Large file size or high memory USB flash drive takes longer time
to read.
The elapsed time displayed is different from the
actual play time.
Copy the data to another USB device or backup the data and
reformat the USB device.

Automatic standby

This setting cannot be selected when “DAB/DAB+” (
[SC-HC38DB]
),
“FM” or “AM” (
[SC-HC38]
(
[Australia[and[New[Zealand[
only)) is the
source.

Display brightness

Changing the unit and remote

control code

To return all settings to the factory preset
When the following situations occur, reset the
memory:
There is no response when buttons are pressed.
You want to clear and reset the memory contents.
1Disconnect the AC mains lead. (Wait for at least
3 minutes before proceeding to step 2.)
2While pressing and holding down [Í/I] on the
unit, reconnect the AC mains lead.
“--------” appears on the display.
3Release [Í/I].
All the settings are returned to the factory preset. You will
need to reset the memory items.

Common problems

Disc operations

USB operations

SC-HC38_DBEB_DBGN_GS~RQT9743-B.book 13 ページ 2013年1月21日 月曜日 午後1時6