Panasonic SC-HT740 Radio and AC cord connections, Preparing the remote control, Use, Simple Setup

STEP5 Radio and AC cord connections

Simple Setup

Preparing the remote control

AM loop antenna	FM indoor antenna	AC power supply cord
		\U.S.A.\and\Canada]

≥Connect the AC power supply cord after all other connections are complete.

≥Using an outdoor antenna (optional) (➜ page 27).

AM loop antenna

Stand the antenna up on its base.

Place the antenna where reception is best. Keep loose antenna cable away from other wires and cables.

Click!

Main unit

AC IN

AC power supply cord

Power plug adaptor

\Others]\Areas\except\U.S.A.\and\Canada]

The illustration shows SC-HT740 for U.S.A. and Canada.

FM indoor antenna

Affix this end of the antenna where reception is best.

Adhesive tape

LOOP

ANT GND

FM ANT 75

LOOP

AM

ANT

EXT

and AC cord connections /

To household AC outlet (AC 120 V, 60 Hz)

[For\areas\except\U.S.A.\and\Canada]

≥If the power plug does not fit your AC outlet

Use the power plug adaptor (included).

If it still does not fit, contact an electrical parts distributor for assistance.

Conserving power

Loosen the terminal screw with a Phillips-head screwdriver.

Black

Red White

While pushing, insert the wire fully.

Re-tighten the terminal screw.

Radio

The main unit consumes a small amount of power, even when it is turned off (For U.S.A. and Canada: approx. 0.4 W or for other areas: approx.

0.9W). To save power when the unit is not to be used for a long time, unplug it from the household AC outlet. You will need to reset some memory items after plugging in the unit.

[Note]

The included AC power supply cord is for use with this unit only. Do not use it with other equipment. Also, do not use cords for other equipment with this unit.

STEP6 Preparing the remote control

Remote control Batteries

Insert so the poles (i and j) match those in the remote control.

Press in and lift up.

Do not:

≥mix old and new batteries.

≥use different types at the same time.

≥heat or expose to flame.

≥take apart or short circuit.

≥attempt to recharge alkaline or manganese batteries.

≥use batteries if the covering has been peeled off.

Mishandling of batteries can cause electrolyte leakage which can severely damage the remote control.

Remove the batteries if the remote control is not going to be used for a long period of time. Store in a cool, dark place.

∫Use

RQT8582

10

R6/LR6, AA

Replace the cover.

≥Do not use rechargeable type batteries.

Aim at the display (➜ page 11), avoiding obstacles, at a maximum range of 7 m (23 feet) directly in front of the unit.