HT740&940En.book | Page5Friday,February | 24, 2006 | 7:47PM | Max: 135 cm (535/32z) |
[HT940] |
|
|
|
|
2 Front speakers | 2 Stands (w th cable) | Bases | 6 Screws | 2 Sliders |
|
|
|
| The speaker height |
|
|
|
| can be adjusted. |
|
|
|
| Min: 110 cm (431/4z) |
Simple Setup
Place the polyfoam underneath the speaker for stability while attaching the speaker to the stand.
1Feed the speaker cable (the shorter part) into the bottom of the speaker and through the slot at the rear.
2While pulling the speaker cable up through the slot, slide
the speaker stand into the bottom of the speaker.
Cable
Speaker
Stand
Polyfoam
3Thread the cable through the middle hole of the slider and fasten the slider with the two screws.
Cable
Slider
2Insert the stand into the base while gently pulling on the end of the cable.
Cable
3 Secure the stand to the base.Screw
Tighten securely.
4 Adjust the speaker height.1 | Loosen the screws until |
|
| the speaker can slide up |
|
| and down the stand. | |
2 | Raise the speaker to the | |
| desired height, and then | screwdriver |
|
|
Assembling the front speakers
Screws |
Tighten securely. | 5 Connect the speaker cable. | |
| ||
| Insert the wire fully. | |
2 Attach the stand to the base. | _: White | |
`: Blue | ||
1 Thread the speaker cable through the base. | Push! | |
For quicker threading, loosely fold the cable in half (do not | Press the speaker cable into the groove. | |
crease), pass the folded portion through the hole, and then pull | ||
| ||
the rest of the cable through the base. | Push excess cable back through the | |
| ||
Cable | slider holder. | |
Rounded side | 6 Secure the speaker cable to the base. | |
Large hole | Slide the cable | |
into the groove. | ||
Base | ||
Cable | ||
|
∫ Preventing the speakers from falling | e.g. [HT740] [HT743] |
≥You will need to obtain the appropriate screw eyes to match the |
|
walls or pillars to which they are going to be fastened. |
|
≥Consult a qualified housing contractor concerning the |
|
appropriate procedure when attaching to a concrete wall or a |
|
surface that may not have strong enough support. Improper |
|
attachment may result in damage to the wall or speakers. |
|
| Rear of the speaker |
String (not included)
Thread from the wall to the speaker and tie tightly.
|
| Approx. | |
Screw eye | Wall | 150 mm | |
(not included) | (529/32z) | ||
|
RQT8582
5