∫Front and surround speaker height
(Assembled diagram)
Speaker | You can adjust within this range. | ||
1,160 mm 750 mm |
|
| 704 mm |
|
|
| |
Pipe |
|
|
|
| 818 mm | 575 mm | Stopper |
Base | screw | ||
|
| Do not | |
|
|
| |
Attach to lower |
| Attach to upper | remove. |
|
| ||
rear of speaker. |
| rear of speaker. |
|
3 Adjust the speaker height.
≥Check the screws you tightened on page 4.
e.g. Attaching the stand to the lower rear of the speaker
1Loosen the attached speaker mounting plate screw until the attached speaker is slightly loose and adjustable.
Be careful not to loosen the screw too much or the speaker may detach and fall.
2With one hand on the base, and the other
holding the speaker, adjust the height of the speaker up and down.
≥After adjusting the height, tighten the screw on the mounting plate securely.
Stopper screw
Screw to stop mounting plate from moving or sliding below this point.
For your reference
You can enjoy good acoustics by adjusting the height of the speaker with the height of the television so the center positions of both are approximately the same.
4 Connect the speaker cables.
1 Twist off the vinyl ends of | Rear speaker | |||||||
panel | ||||||||
the speaker cables. | ||||||||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
Insert the wire fully.
_: Copper
`: Silver
Push!
2Press the speaker cable into the groove.
If there is any excess speaker cable, detach the rubber cap on the top of the pipe and thread the speaker cable into the opening while pulling the speaker cable from the bottom of the base.
5 Fasten the speaker cable to the base.
1 Press the speaker | 2 Fit the speaker |
cable and thread | cable into the |
between the | base cover |
hooks. | groove as far as |
| possible. |
Rear side of base | Cable |
|
Front and surround speaker assembly
∫Preventing the speakers from falling over (Front and surround speakers)
Preparation |
|
|
Attach screw eyes (not included) to secure the speakers to the wall |
| Screw eye (not included) Wall |
(‹diagram right). | e.g. | String (not included) |
≥You will need to obtain the appropriate screw eyes to match the |
|
|
walls and pillars to which the screw eyes are going to be |
|
|
fastened. |
|
|
≥Consult with a qualified housing contractor concerning the |
|
|
appropriate procedure when attaching to a concrete wall or a |
|
|
surface that may not have strong enough support. Improper |
| Approx. 150 mm |
attachment may result in damage to the wall or speakers. |
| |
|
|
1Thread the string (not included) through the slot on the
rear of the speaker to prevent it from falling over. |
| Rear of the speaker |
|
2Loop the string through the screw eye and tie tightly.
RQT7429
5
