Panasonic SC-HT75, SC-HT95 warranty Maintenance, Picture, Listening to the radio, Unit displays

Picture

Picture distorted.	≥Some distortion is normal during SEARCH.
No picture.	≥Ensure that the television is connected properly. 8
	≥Make sure the television is on.
	≥Ensure the television’s video input setting (e.g., VIDEO 1) is correct.
	≥If “This disc is PAL system. The output is sound only.” is on the television, then you have loaded a
	PAL system DVD-Audio and only the audio portion of the disc can be played.
	[HT95]
	≥The unit does not output video signals from the VIDEO OUT and S-VIDEO OUT terminals when the
	“PROGRESSIVE OUT” indicator is on. Press [PROGRESSIVE OUT] to turn progressive out off.
The picture shown on the	≥Ensure that the unit is connected directly to the television, and is not connected through a video
television is not normal.	cassette recorder.
	≥Go to the Video menu in the ACTION screen, and change “TV Aspect” to suit your television. You
	may also need to change the screen mode on the television itself. :
	[HT95]
	If your television cannot change the aspect when input is progressive
	Press [PROGRESSIVE OUT] so the indicator goes out. Output will now be interlace.
[HT95]	≥Turn progressive output off. This problem is caused by the editing method or material used on the
There is ghosting when	DVD, but should be corrected if you use interlace output.
progressive output is on.
Picture quality is poor.	≥Check the settings in the On-Screen Menu Icons’ video menu. E
[HT95]	≥Adjust the horizontal position with the on-screen menu icons. E
The picture is off center when
using progressive output.
The picture on the television	≥The location and orientation of the antenna are incorrect. If you are using an indoor antenna,
disappears or stripes appear on	change to an outdoor antenna. Q
the screen.	≥The television antenna wire is too close to the unit. Separate the antenna wire of the television
	from the unit.

Listening to the radio

Noise is heard.	≥Adjust the position of the FM or AM antenna. 9
The stereo indicator flickers or	≥Use an outdoor antenna. Q
doesn’t light.
Sound is distorted.
A beat sound is heard.	≥Turn the television off or separate it from the unit.
A low hum is heard during AM	≥Separate the antenna from other cables and cords.
broadcasts.

Unit displays

This unit’s display is off.	≥Press [FL DISPLAY] to turn the display on. K
“NO PLAY”	≥You inserted a disc the unit cannot play; insert one it can. 5
“NO DISC”	≥You haven’t inserted a disc; insert one.
	≥You haven’t inserted the disc correctly; insert it correctly. <
“F61”	≥Check and correct the speaker cord connections. 7	Reference
	If this does not fix the problem, there is a power supply problem. Call 1-800-211-7262 for support.
“DVD U11”	≥The disc is dirty. Wipe it with a soft cloth. 5
“ERROR”	≥Incorrect operation performed. Read the instructions and try again.
	≥The track playing has been recorded with a nonstandard system.
“DVD H∑∑”	≥Trouble is likely to have occurred. The number following “H” depends on the status of the unit.
	Reset procedure:
∑∑ stands for a number.	Press [Í] to switch the unit to the standby mode and then back to ON. Alternatively, press [Í] to
	switch the unit to the standby mode, disconnect the AC power supply cord, and then reconnect it.
	≥If the service numbers fail to clear, note the service number and contact a qualified service person.
“TAKE OUT DISC”	≥A problem has occurred with the tray mechanism. The tray will open automatically. Take out the disc and close
	the tray. The unit will make the disc changing noises for a few moments and then should operate normally.
Television displays
No on-screen display.	≥Go to Display in the ACTION menus, and select “On” for “On-Screen Messages”. L
On-Screen Menu Icons not	≥Press [3, 4] while the rightmost icon is highlighted to move them down. C
displayed or only partially
displayed on the television.
The disc’s menu is displayed in a	≥Go to Disc in the ACTION menus, and select the preferred language for “Menus”. L
different language.

Maintenance

To clean this unit, wipe with a soft, damp cloth.

≥Never use alcohol, paint thinner or benzine to clean this unit.

≥Before using chemically treated cloth, read the instructions that came with the cloth carefully.

Before moving the unit, ensure the disc tray is empty.

Failure to do so will risk severely damaging the disc and the unit.

35

RQT6183