Using the IR Blaster
With the IR Blaster connection, it is possible to send the IR signal received by this unit’s remote control signal sensor to the TV’s sensor.
Use the TV’s remote control within this unit’s remote control signal sensor’s operation range.
≥For the operation range, refer to page 6.
1 Connect the jack plug to this unit’s Ir SYSTEM terminal.
2 Place the infrared emitter in sight of the TV’s remote control signal sensor.
Ir SYSTEM
≥ For the location of the TV’s remote control signal sensor, refer | |
|
| |||
to the operating instructions for the TV. |
|
| ||||
| ||||||
3 Aim the TV’s remote control at this unit’s remote |
|
|
|
|
| |
|
|
|
|
| ||
control sensor and operate the TV. |
|
|
|
|
| |
|
|
|
|
| ||
≥ For the location of this unit’s remote control signal sensor, refer | A Infrared emitter | |||||
to page 6. | ||||||
|
|
|
|
| ||
≥Make sure to clean the surface, where the adhesive tape is to be attached.
≥If you peel off the adhesive tape, the surface may become damaged and exposed adhesive may remain. Once you have confirmed the TV is operating correctly, secure it by attaching the adhesive tape.
≥The supplied IR Blaster is only compatible with Panasonic TVs.
∫Placement example
On the rear of this unit:
TV remote control signal sensor
Adhesive tape
18
