14 RQT9777
The speakers can be wall mounted by drilling screws into the wall, etc.
Make sure that the screw used and the wall are strong enough to support the weight of at least 33 k
g
(72.8 lbs).
The screws and other items are not supplied as the type and size will vary with each installation.
≥For details about the required screws, refer to the diagram below the step “Drive a screw into the wall.”
(>15).
≥For a safety measure to prevent the speakers from falling, refer to page 20.
≥To prevent damage or scratches, lay down a soft cloth and perform the assembly on it.
Attach the stand neck.
≥The two speakers are interchangeable.
≥Keep the screws out of reach of children to prevent swallowing.
Connect the speaker cables.
§ If you have difficulty inserting the cable, try straightening the speaker cable and then bending the
cable about 20 mm (25/32q) from the tip, at an angle of approx. 45o (as illustrated above).
Place the speakers vertically
∏2 Speakers ∏2 Speaker cables
WHITE: Left
RED: Right
∏2 Stand necks
∏2 Screws
AScrew (supplied)
≥Tighten securely.
1 Insert the wire fully.
r: White
s: Blue line
≥Insert the wire fully, taking
care not to insert beyond
the wire insulation.
2 Press into the groove.
45
Push
SC-HTB370PPC_RQT9777-1P_mst.book Page 14 Tuesday, January 29, 2013 11:48 AM