Using the Dolby Virtual

Speaker effect

Depending on your preference, It is possible to turn off the 3D surround effect and the clear-mode dialog effect.

While pressing and holding [SOUND] on the remote control, press and hold [VOL i] on the main unit for more than 4 sec.

“STANDARD” indicator blinks:

3D surround effect and clear-mode dialog effect is on.

“STEREO” indicator blinks:

3D surround effect and clear-mode dialog effect is off.

While the setting is displayed, press [SOUND] to change the setting.

≥The setting changes each time [SOUND] is pressed.

≥The indicator for the selected setting blinks for 20 sec and then exits the setting mode.

≥This setting will be reset to on when the main unit is turned off.

≥When off is selected, the dialog effect level cannot be adjusted.

Dimmer mode

You can turn off dimmer mode and keep the LED indicators bright.

While pressing and holding [INPUT SELECTOR] on the remote control, press and hold [s VOL] on the main unit for more than 4 sec to turn off Dimmer mode.

≥The indicator for the current condition will turn brighter.

≥The setting is maintained until it is changed again.

≥Default setting of this function is on.

To turn on dimmer mode, repeat the operation above. After performing the operation, the indicator for the current condition will be dim.

Others

∫Remote control code

When other Panasonic devices respond to this system’s remote control, change the remote control code on this system and the remote control.

Preparation

≥Turn off all other Panasonic products.

≥Turn on the main unit.

Change the remote control code to code 2:

1Aim the remote control at the main unit’s remote control sensor.

2Press and hold [MUTE] and [ ] on the remote

control for more than 4 sec.

≥All the indicators will blink for 10 sec when the code of this system is changed.

≥The setting is maintained until it is changed again.

≥If the main unit does not operate after changing the code, repeat steps 1 and 2.

≥To change the remote control code to code 1, repeat the steps above, but replace [ ] with [INPUT SELECTOR].

∫To reduce the clear-mode dialog effect

When the dialog does not sound natural while the volume is set low, It is possible to reduce the dialog enhancing effect as follows:

While pressing and holding [SOUND] on the remote control, press and hold [s VOL] on the main unit for more than 4 sec.

≥All the indicators will blink once when the clear-mode dialog effect is reduced.

≥Even if clear-mode dialog effect is reduced, dialog effect level is still adjustable.

To reset the setting, return to the factory preset. (> 22)

∫To turn off the volume limitation

If a state of the lowered volume disturbs you every time the main unit turns on, for example, it is possible to turn off this function as follows:

While pressing and holding [MUTE] on the remote control, press and hold [VOL i] on the main unit for more than 4 sec.

≥All the indicators will blink once when the volume limitation is turned off.

To reset the setting, return to the factory preset. (> 22)

RQT9763 21

Operations