Panasonic SC-PT754, SC-PT660 manual Batteries, Use, Using an FM/AM outdoor antenna optional, Do not

Using an FM/AM outdoor antenna (optional)

Use outdoor antenna if FM/AM radio reception is poor.

≥Disconnect the antenna when the unit is not in use.

≥Do not use the outdoor antenna during an electrical storm.

FM outdoor antenna

[Using a TV antenna (not included)]

≥The antenna should be installed by a competent technician.

AM outdoor antenna

[Using a vinyl wire (not included)]

Run a piece of vinyl wire horizontally across a window or other convenient location.

	AM ANT
5.0 m to 12 m	EXT
	LOOP
(16 ft to 39 ft)

LOOP ANT GND

Simple Setup

75 ≠ coaxial cable§	Leave the AM loop	FM ANT
		(75 )
(not included)	antenna connected.

Antenna plug (not included)

§Rework your outdoor antenna’s 75 ≠ coaxial cable as follows.

1 Remove a piece of the outer		2 Carefully pull the tabs apart		3 Install the coaxial cable.
vinyl insulator.		to remove the cover.		Clamp the cable conductor, and
				wind it on so that it does not
				contact anything else.
10 mm (13/32z)			
10 mm (13/32z)	Peel back		
	7 mm (9/32z)			Clamp with pliers

step4 AC cord connection

Main unit

4Attach the cover.

AC cord connection / Preparing the remote control

AC IN

AC power supply cord (included)

Main unit

/

To household AC outlet (AC 120 V, 60 Hz)

Conserving power	[Note]
The main unit consumes a small amount of power when it is turned off		The included AC power supply cord is for use with the main unit only.
(main unit: approx. 0.3 W). To save power when it is not to be used for a		Do not use it with other equipment. Also, do not use cords for other
long time, unplug it from the household AC outlet.		equipment with the main unit.
You will need to reset some memory items after plugging in the main
unit.

step5 Preparing the remote control

Cable connections

∫Batteries

Insert so the poles (i and j) match those in the remote control.





R6/LR6, AA

≥Do not heat or expose to flame.

≥Do not leave the battery(ies) in an automobile exposed to direct sunlight for a long period of time with doors and windows closed.

Do not:

≥mix old and new batteries.

≥use different types at the same time.

≥take apart or short circuit.

≥attempt to recharge alkaline or manganese batteries.

≥use batteries if the covering has been peeled off.

Mishandling of batteries can cause electrolyte leakage which can severely damage the remote control.

Remove the batteries if the remote control is not going to be used for a long period of time. Store in a cool, dark place.

CAUTION	∫ Use
Danger of explosion if battery is incorrectly replaced. Replace only	Aim at the remote control signal sensor (➜ 13), avoiding obstacles,
with the same or equivalent type recommended by the manufacturer.	at a maximum range of 7 m (23 ft) directly in front of the unit.
Dispose of used batteries according to the manufacturer’s instructions.

RQTX0094

9