Using an FM/AM outdoor antenna (optional)
Use outdoor antenna if FM/AM radio reception is poor. | AM outdoor antenna |
≥Disconnect the antenna when the unit is not in use. | [Using a vinyl wire (not included)] |
≥Do not use the outdoor antenna during an electrical storm. | Run a piece of vinyl wire horizontally across a |
| window or other convenient location. |
FM outdoor antenna
[Using a TV antenna (not included)] |
| AM ANT |
≥The antenna should be installed by a |
| |
| LOOP ANT GND | |
competent technician. |
| |
5.0 m to 12 m | EXT | |
| LOOP | |
| (16 ft to 39 ft) | |
|
|
75 ≠ coaxial cable§ | Leave the AM loop | FM ANT |
(not included) | (75 ) | |
antenna connected. |
| |
|
| |
Antenna plug (not included) |
| Main unit |
|
|
§Rework your outdoor antenna’s 75 ≠ coaxial cable as follows.
1 Remove a piece of the outer | 2 Carefully pull the tabs apart | 3 Install the coaxial cable. | 4 Attach the cover. | |
vinyl insulator. | to remove the cover. | Clamp the cable conductor, and |
| |
|
|
| wind it on so that it does not |
|
10 mm (13/32z) |
|
| contact anything else. |
|
| |
|
| |
|
|
|
| |
Peel back | | |
|
|
10 mm (13/32z) |
|
| ||
7 mm (9/32z) |
|
| Clamp with pliers |
|
step3 AC cord connection
AC IN
AC power supply cord | Main unit |
| |
(included) | To household AC outlet |
| |
| (120 V, 60 Hz) |
Conserving power | [Note] |
The main unit consumes a small amount of power when it is turned off | The included AC power supply cord is for use with the main unit only. |
(approx. 0.3 W). To save power when it is not to be used for a long time, | Do not use it with other equipment. Also, do not use cords for other |
unplug it from the household AC outlet. | equipment with the main unit. |
You will need to reset some memory items after plugging in the main |
|
unit. |
|
step4 Preparing the remote control
Simple Setup
Cable connections / AC cord connection / Preparing the remote control
∫Batteries
Insert so the poles (i and j) match those in the remote control.
R6/LR6, AA
≥Do not heat or expose to flame.
≥Do not leave the battery(ies) in an automobile exposed to direct sunlight for a long period of time with doors and windows closed.
Do not:
≥mix old and new batteries.
≥use different types at the same time.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a long period of time. Store in a cool, dark place.
CAUTION | ∫ Use |
Danger of explosion if battery is incorrectly replaced. Replace only with | Aim at the remote control signal sensor (➜ 13), avoiding obstacles, |
the same or equivalent type recommended by the manufacturer. | at a maximum range of 7 m (23 ft) directly in front of the unit. |
Dispose of used batteries according to the manufacturer’s instructions. |
|
|
|
RQTX0275
9