USB B
█Manual presetting

1 Press [3] or [5] (main unit: [5/6] or [2/3]) to tune in to the station and then press [OK].

“PGM” is shown.2 Press the numeric buttons to select a preset number.The new station replaces any station that occupies the same preset number.Do steps 1 and 2 again to preset more stations.
█Selecting a preset station
Press the numeric buttons, [2] or [6] to select the preset station.

Using the main unit

1 Press [TUNE MODE] to select “PRESET”.2 Press [2/3] or [5/6] to select the preset station.

AM allocation setting

By main unit onlyThis system can also receive AM broadcasts allocated in 10 kHz steps.1 Press [RADIO/AUX] to select “FM” or “AM”.2 Press and hold [RADIO/AUX].

After a few seconds, the display panel shows the current minimum radio frequency. Release the button when the minimum frequency changes.

•To go back to the initial setting, do the above steps again.•After you change the setting, preset frequencies are erased.

Recording

This system can record up to the followings depending on the available storage capacity of the USB device in

and the mode selected:•MP3 disc and CD-DA to USB B−255 folders or a total of 4000 tracks.•USB A-AUDIO and others to USB B−800 folders (maximum 999 tracks in an album) or a total of 8000 tracks.To check storage space

In the stop mode (except for DVD/CD, USB A-VIDEO and USB B-VIDEO), press [FL DISPLAY].

•“UPDATE” is shown when the system is reading the device.•“NODEVICE” is shown if there is no USB device connected to USB B .

Panasonic cannot be held responsible on the action of consumer to record copyrighted contents which can cause copyright infringement.

Note:

•All recordings are in “.mp3” format.•You cannot do recording when you are using random playback mode.•You cannot do recording when DJ jukebox is switched on.•Repeat playback mode is off during recording.•A new album is added each time you do a recording.•The sequence of album may change after the recording.•The recordings are kept in a folder named “REC_DATA” in the USB device.•USB status indicator blinks in red during USB recording.

Basic recording

1 Select the source you want to record. CD-DAPrepare the disc playback mode (Z12, “Play mode”)Make sure the disc is stopped.RadioTune in to the radio station.External equipmentConnect and play the equipment (Z22, “External equipment”).2 Press [USB REC 7/9] to start recording.The name of the folder that keeps the recording is shown.

Stop

Press [8]. “WRITING” is shown.

 

recording

 

 

 

 

 

Pause

Press [USB REC 7/9] during recording.

 

recording

Press again to continue recording.

 

 

Note:

 

 

You can pause during recording from

 

 

radio, AUX 1 or AUX 2 (except in

 

 

SYNCHRO mode). A track mark is added

 

 

every time you pause (Z18, “Adding

 

 

track marks”).

 

 

 

 

Note:

 

RQT9951

• Wait for a few seconds for the system to prepare the USB

 

device before recording starts.

 

• When the next track of the CD-DA disc is being recorded, it

17

will be shown on the display.