█HDMI progressive video
There is a ghosting effect when the HDMI progressive output is on.
•This problem is caused by the editing method or material used on
(Z 7, 16)
Remote control code
When other Panasonic equipment responds to the remote control of this system, change the remote control code for this system.
Preparation
Press [RADIO/AUX] to select “AUX 1” or “AUX 2”.
█To set the code to “REMOTE 2”
1 Press and hold [RADIO/AUX] on the main unit and [2] on the remote control until “REMOTE 2” is shown.
2 Press and hold [OK] and [2] for a minimum of
4seconds.
█To set the code to “REMOTE 1”
1 Press and hold [RADIO/AUX] on the main unit and [1] on the remote control until “REMOTE 1” is shown.
2 Press and hold [OK] and [1] for a minimum of 4 seconds.
Note:
After you set the code, you can continue to use the TV operation buttons on the remote control to operate a Panasonic TV (Z 9).
System memory reset
Reset the memory when the following situations occur:
•There is no response when buttons are pressed.
•You want to clear and reset the memory contents.
1 Disconnect the AC mains lead.
2 While you press and hold [1] on the main unit, connect the AC mains lead again.
Continue to press and hold the button until “– – – – – – –
3 Release [1].
All the settings are set back to the factory preset. It is necessary to set the memory items again.
RQT9951
Specifications
█Amplifier section
RMS output power stereo mode |
| |
Front Ch | 275 W per channel (3 ), 1 kHz | |
Total RMS stereo mode power | 550 W (30% THD) | |
PMPO output power |
| 6000 W |
█Tuner, terminals section
Preset station | FM 30 stations |
| AM 15 stations |
Frequency modulation (FM)
Frequency range
87.50 MHz to 108.00 MHz (50 kHz step)
Antenna terminals75 
(unbalanced) Amplitude modulation (AM)
Frequency range
| 522 kHz to 1629 kHz (9 kHz step) |
Mic jack | 520 kHz to 1630 kHz (10 kHz step) |
| |
Terminal | Mono, 6.3 mm jack (2 system) |
Sensitivity | 0.7 mV, 1.2 k |
AUX 1 |
|
Audio input | Pin jack (1 system) |
AUX 2 |
|
Sensitivity | 100 mV, 4.7 k |
█ USB section
USB port |
|
USB standard | USB 2.0 full speed |
Media file format support | MP3 (*.mp3) |
USB AUDIO | |
USB VIDEO JPEG (*.jpg, *.jpeg), Xvid (*.xvid, *.avi) | |
USB device file system | FAT12, FAT16, FAT32 |
USB port power | 500 mA (max) |
Bit rate | Up to 4 Mbps (Xvid) |
USB recording |
|
Bit rate | 128 kbps |
USB recording speed | 1x |
Recording file format | MP3 (*.mp3) |
█Bluetooth® section
Version | Bluetooth® Ver. 2.1 + EDR |
Class | Class 2 |
Supported profiles | A2DP, AVRCP, SPP |
Operating frequency | 2.4 GHz band, |
Operation distance | 10 m line of sight |
30