4/REW/4,
3/FF/¢
STOP7,
Top of the unit
OPEN
1
3
2
Cassette tapes
1 Press [OPEN 0] to insert a cassette.
Close the lid by hand.
2 Press [TAPE 3] to start playback.
Repeat step 1 and 2 to play the other side of the tape.
3 Adjust the volume.
To | Action |
stop tape playback | Press [STOP 7, – DEMO]. |
start one touch play | Press [TAPE 3] when the system is |
| OFF with the cassette loaded. |
Press [4/REW/4] or [3/FF/¢] in | |
rewind | the stop mode. |
|
|
Cassette tape selection and care
Types of cassettes which can be played correctly Use normal position tapes.
High position and metal position tapes can be played, but the unit will not be able to do full justice to the characteristics of these cassettes.
•Tapes exceeding 100 minutes are thin and can break or get caught in the mechanism.
•Tape slack can get caught up in the mechanism and should be wound up before the tape is played.
•Endless tapes can get caught up in the deck’s moving parts if used incorrectly.
To find the beginning of a program (TPS: Tape Program Sensor)
Listening operations
20
RQT7369
1 OPEN 0
B
B
Insert inside the guides
Forward side
2 TAPE 3
3 VOLUME
DOWN | UP |
|
|
|
|
TPS finds the beginning of a track and resumes play from there. Each press increases the number of tracks skipped, up to a maximum of 9.
Press [4/REW/4] or [3/FF/¢] during play.
Note
The TPS function searches for silent parts of about 4 seconds in length which are normally found between tunes. As a result, it may not function properly in the following cases:
•With short silent parts
•When noise occurs between tunes
•With silent parts found within tunes