Panasonic SDR-SW20PC Plug the DC plug into the DC input terminal on Unit, Status indicator

The battery is not charged at the time of purchase. Be sure to charge it before use.

For charging time (P.24)

We recommend using Panasonic batteries. (VW-VBJ10)

If you use other batteries, we cannot guarantee the quality of this product.

CAUTION

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's instructions.

6Open the terminal cover.

OPEN

Slide the lock to the OPEN side and lift the projection with a finger to open.

Projection

7Plug the DC plug into the DC input terminal on the

unit.

Status indicator

Flashing red at approx. 1 second intervals: Charging in progress

Off: Charging complete

If the status indicator does the following:

Does not flash:

Remove and reinsert the battery, and disconnect and reconnect the AC adaptor. If the status indicator still does not flash, contact your dealer.

Flashes rapidly at approx. 0.25 seconds intervals: The battery cannot be charged. Try doing the following.

•Remove and reinsert the battery, and try recharging the battery.

•The battery temperature or surrounding temperature is too high/low, therefore wait until the unit and the battery are at suitable temperatures and try recharging the battery.

If battery charging still does not commence, contact your dealer.

Flashes slowly at approx. 3 seconds intervals: Charging requires time for the following reasons:

•The battery has been excessively discharged.

•The battery temperature or ambient temperature is too high/low.

If power to the unit is activated while the battery is charging, the AC power supply will be used and charging interrupted.

VQT1M21 23