48
Technical Information (Continued)

4:3 side bars

Do not display a picture in 4:3 mode for an extended period, as this can cause
“Image retention” to remain on either or both sides of the display field.
To reduce the risk of such “Image retention”, change the brightness of the side
bars.
See pages 28-29 for more information
The side bar may flash (alternate black/white) depending on the picture. Using
Cinema mode will reduce such flashing (See below).
Side Bar
4:3
Screen
Display
Image retention

Scrolling bar

Scrolling bar: To prevent “Image retention”, scrolls white vertical bar from left to right on a black screen.
Press any key except the POWER key to return to previous screen.
You will return to the previous screen if no key operation has been performed for 15 minutes.
See pages 28-29 for more information
[Scrolling bar]

Input signals that can be displayed

* Mark: Applicable input signal for Component (Y, PB, PR) and HDMI
horizontal
frequency (kHz) vertical
frequency (Hz) COMPONENT HDMI
525 (480) / 60i 15.73 59.94 **
525 (480) /60p 31.47 59.94 **
750 (720) /60p 45.00 59.94 **
1,125 (1,080) /60i 33.75 59.94 **
1,125 (1,080)/60p 67.43 59.94 *
1,125 (1,080)/60p 67.50 60.00 *
1,125(1,080)/24p 26.97 23.98 *
1,125(1,080)/24p 27.00 24.00 *

H size

Aspect Ratio: 4:3

Size 1 Size 2 The width will be decreased on both sides to
reduce noise.

Aspect Ratio: FULL/JUST(H-FILL/ZOOM)

Size 1 Size 2 The width will be increased on both sides to
reduce noise.
See pages 26-27 for more information
Note
Signals other than those shown above may not be displayed properly.
The above signals are reformatted for optimal viewing on your display.