Problem | Actions |
Screen
Sound
HDMI
Other
Chaotic image, noisy
No image can be displayed
Blurry or distorted image
(no sound or low volume)
Neither image nor sound is produced
No sound is produced 
Sound level is low or sound is distorted
Sound is unusual
An error message appears
"Control with HDMI" function does not work
TV unit goes into "Standby mode"
An error message appears
•Set "D. PNR" in the Picture menu (to remove noise).
•(p. 14)
Check nearby electrical products (car, motorcycle, fluorescent lamp).
•Is "Colour" or "Contrast" in the Picture menu set to the minimum? (p. 14)
•Check "Colour system" (p. 16)
•Reset channels. (pp. 9 and 16)
•Is the unit in "AV mode"?
•Is the mains lead plugged into the socket outlet?
•Is the TV unit turned On?
•Check Picture menu (p. 14) and volume.
•Is "Sound Mute" active? (p. 7)
•Is the volume set to the minimum?
•Sound signal reception may be deteriorated.
•Check "Sound system" (p. 16)
•Set the sound setting of the connected equipment to "2ch L.PCM".
•Check the "HDMI input" setting in the Sound menu.
•If digital sound connection has a problem, select analogue sound connection. (p. 26)(p. 14)
•Contact the authorized Service Centre.
•Switch the TV unit on again with the equipment on.
•Set(p. 20)"Control with HDMI" to "Off", then set to "On" again.
•The sleep function is activated.
•The TV unit enters "Standby mode" about 30 min. after broadcasting ends.
•Follow the message's instructions.
•If the problem persists, contact the authorized Service Centre.
•Frequently Asked Questions FAQs, etc.
29
