Panasonic TH-50PV80AZ Screen, Hdmi, Other, Sound, FAQs, Problem, Actions, Chaotic image, noisy

FAQs

Problem	Actions
Chaotic image, noisy	Set “P-NR” in the Picture Menu (to remove noise). (p. 22)
	•Check nearby electrical products (car, motorcycle, fluorescent
	•lamp).

Screen

No image can be displayed	•(p.Is “Colour”22)	or “Contrast” in the Picture Menu set to the minimum?
	Check Colour System. (p. 27)
	••Check AV Colour System. (p. 23)
Blurry or distorted image	•Reset programme. (p. 27)
(no sound or low volume)

Unusual image is displayed •again.Turn off the TV with Mains power On / Off switch, then turn it on

No sound is produced

Sound

Sound level is low or sound is distorted

•Is “Sound mute” active? (p. 9)

•Is the volume set to the minimum?

•Sound signal reception may be deteriorated.

•Check Sound system. (p. 27)

HDMI

	Set the sound setting of the connected equipment to “2ch L.PCM”.
Sound is unusual	•Check the “HDMI1 / 3 Input” setting in the Sound Menu. (p. 22)
	•If digital sound connection has a problem, select analogue sound
	•connection. (p. 41)
Pictures from external equipment	Is the HDMI cable connected properly? (p. 38)
	•Turn Off the TV and equipment, then turn them On again.
are unusual when the equipment	•Check an input signal from the equipment. (p. 42)
is connected via HDMI	••Use an equipment compliant with EIA/CEA-861/861B.

TV goes into “Standby mode”

Other

The remote control does not work

•Off Timer function is activated.

•Theends.TV enters “Standby mode” about 30 mins. after broadcasting

•Are the batteries installed correctly? (p. 6)

•Has the TV been switched On?

44