Panasonic TH-42PF11UK manual Sync, Sdi Through, Input signal display, Setting RGB sync signal

SET UP for Input Signals

SYNC

Select SIGNAL from the “SET UP” menu during RGB input signal.

Press to select the “SYNC”.

Press to adjust.

SIGNAL	[ RGB ]
SYNC	AUTO
3 : 2 PULLDOWN	OFF
XGA MODE	1024 × 768

Setting RGB sync signal

Confirm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT signal).

AUTO:	The H and V sync or synchronized signal are automatically selected.
	If both input, it is selected the H and V sync.
ON G:	Uses a synchronized signal on the Video G signal, which is input from
	the G connector.
VBS:	Uses a synchronized signal of Composite Sync input, which is input
	from the HD connector.

SYNC	AUTO
SYNC	ON G
SYNC	VBS

SDI THROUGH

Set the active through function of the Dual Link HD-SDI Terminal Board (TY-FB11DHD).

Note:

Settings can only be performed for this menu when a slot mounted with a Dual Link HD-SDI Terminal Board (TY-FB11DHD) is selected.

Press to select the “SDI THROUGH”.

Press to select “ON” or “OFF”.

ON: Enables active through. OFF: Disables active through.

SIGNAL	[ Digital ]
3 : 2 PULLDOWN	OFF
SDI THROUGH	OFF
REFRESH RATE	100 Hz
NOISE REDUCTION	OFF

Input signal display

Displays the frequency and the type of the current input signal.

This display is valid only for COMPONENT/RGB/PC and Digital input signal.

Display range:
Horizontal	15	- 110 kHz
Vertical	48	- 120 Hz

The dot clock frequency is displayed during digital signal input.

H-FREQ. 63.98 kHz

V-FREQ. 60.02 Hz SIGNAL FORMAT 1280×1024/60

H-FREQ. 63.98 kHz

V-FREQ. 60.02 Hz

DOT CLOCK FREQ. 108.0 MHz

SIGNAL FORMAT 1280×1024/60

43