Panasonic TH-65PZ750U quick start Side Bar, Input signal that can be displayed

PC Input Terminals Connection

Split - Screen

Side Bar

Do not display a picture in 4:3 mode for an extended period, as this can cause “Image		Side Bar	Image retention
retention” to remain on either or both sides of the display field.
To reduce the risk of such “Image retention”, change the brightness of the side bars.	4:3
The side bar may flash (alternate black/white) depending on the picture. Using		Screen
•Studio ref mode will reduce such flashing (See p. 54).		Display

•TV screen (RF input) cannot be displayed in both main and split frame simultaneously.

•The Split-screen feature is not available when using PC and SD Card viewing mode as a source. HDMI input cannot be displayed in Split frame.

Input signal that can be displayed

* Mark: Applicable input signal for Component (Y, PB, PR), HDMI and PC

			horizontal frequency (kHz)	vertical frequency (Hz)	COMPONENT	HDMI	PC
525	(480) / 60i			59.94	*	*
			15.73
525	(480) /60p		31.47	59.94	*	*
750	(720) /60p		45.00	59.94	*	*
1,125		(1,080) /60i	33.75	59.94	*	*
1,125		(1,080) /60p	67.43	59.94		*
1,125		(1,080) /60p	67.50	60.00		*
640	× 400 @70		31.47	70.08			*
640	× 480 @60		31.47	59.94			*
Macintosh13” (640 × 480)			35.00	66.67			*
640	× 480 @75		37.50	75.00			*
852	× 480 @60		31.47	59.94			*
800	× 600 @60		37.88	60.32			*
800	× 600 @75		46.88	75.00			*
800	× 600 @85		53.67	85.08			*
Macintosh16” (832 × 624)			49.73	74.55			*
1,024		× 768 @60	48.36	60.00			*
1,024		× 768 @70	56.48	70.07			*
1,024		× 768 @75	60.02	75.03			*
1,024		× 768 @85	68.68	85.00			*
Macintosh 21” (1,152 × 870)			68.68	75.06			*
1,280		× 1,024 @60	63.98	60.02			*
1,366		× 768 @60	48.36	60.00			*

Note

•Signals other than above may not be displayed properly.

•The above signals are reformatted for optimal viewing on your display.

•Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)

•Some PC models cannot be connected to the set.

•There is no need to use an adapter for computers with IBM PC/AT compatible D-sub 15P terminal.

•The maximum resolution: 1,280 × 1,024

If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.

•Signal Names for D-sub 15P Connector

				Pin No.	Signal Name	Pin No.	Signal Name	Pin No.	Signal Name
11	12	13	14	15	R	6	GND (Ground)	11	NC (not connected)
6 7		8	9 10		G	7	GND (Ground)	12	NC
1	2	3	4	5	B	8	GND (Ground)	13	HD/SYNC
					NC (not connected)	9	NC (not connected)	14	VD
Pin Layout for PC Input Terminal 5					GND (Ground)	10	GND (Ground)	15	NC

Technical Information FAQs, etc.

55