Connections
AUDIO OUT Terminals connection
R L
AUDIO OUT
Stereophonic sound code audio equipment
– How to Unfasten the AC cord
Loosen the fixing band securing the AC cord.
To loosen:
Push the catch
Pull 
–Cable fixing bands
Secure any excess cables with bands as required.
Note:
Two fixing bands are supplied with this unit. In case of securing cables at three positions, please purchase it separately.
Pass the attached cable fixing band through the clip as shown in the figure.
1
To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.
To tighten: | To loosen: |
| Push the catch |
Pull |
|
2 | Pull |
| R AUDIO | L | PR/CR/R PB/CB/B | Y/G |
| AUDIO |
| R | L |
| COMPONENT/RGB IN |
|
|
|
|
|
| ||
SLOT1 | SLOT2 |
| SLOT3 |
| PC | IN | SERIAL | AUDIO OUT | |
Optional Terminal |
| Dual HDMI Terminals |
| COMPONENT/RGB IN and |
| From EXTERNAL |
Board Insert Slot |
| (equivalent of Dual |
| Audio IN Terminals (equivalent |
| monitor terminal |
(covered) |
| HDMITerminal Board |
| of BNC Component Video |
| on Computer |
|
|
| Terminal Board |
| (see page 10) | |
|
| (see page 12) |
| (see page 12) |
|
|
|
|
|
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
From SERIAL Terminal on Computer (see page 11)
From input on audio amplifier (see page 9)
9
