Initial selections
Selecting the input signal
Select the input signals to be connected by installing the optional Terminal Boards.
Press to select the input signal to be played back from the equipment which has been connected to the Plasma Display.
Input signals will change as follows:
INPUT1 INPUT2 INPUT3 PC
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Input terminal will not be selected if the terminal board is not installed into the SLOT.
• Select to match the signals from the source connected to the component/RGB input terminals. (see page 30)
•In 2 screen display, the same input mode cannot be selected for the main picture and sub picture.
•Image retention (image lag) may occur on the plasma display panel when a still picture is kept on the panel for an extended period. The function that darkens the screen slightly is activated to prevent image retention (see page 40), but this function is not the perfect
solution to image retention.
INPUT MENU 
VOL
ENTER/
Swing up the door at “PULL”.
Selecting the On-Screen Menu Language
Press to display the SET UP menu. Press to select OSD LANGUAGE.
Press to select your preferred language.
Selectable languages
English(UK) 
Deutsch
Français
Italiano
Español
ENGLISH(US)
.......(Chinese)
.......(Japanese)
Русский .......(Russian)
SET UP | 1/2 |
SIGNAL
SCREENSAVER
| RGB |
|
|
|
|
INPUT LABEL | PC |
|
|
|
|
POWER SAVE | OFF |
|
|
|
|
STANDBY SAVE | OFF |
|
|
|
|
POWER MANAGEMENT | OFF |
|
|
|
|
AUTO POWER OFF | OFF |
|
|
|
|
OSD LANGUAGE | ENGLISH (US) |
13
