Options Adjustments
Item |
|
|
|
| Adjustments |
| Off | 1 | 2 | 3.... | 30 |
| You can set the | ||||
| to turn on the multiple displays that are set together. | ||||
| Set each display’s setting individually. | ||||
| Off: |
| The display will be turned on at the same time as POWER switch is pressed. | ||
| 1 to 30 (sec.): Set the | ||||
|
|
| After pressing POWER switch, the display will be powered on with time delay depending on this | ||
Power On Screen | Notes: |
| setting. |
| |
|
|
|
| ||
Delay | • During this function is working, the power indicator is blinking green. | ||||
•This function also works when the power recovers from failure or after plugging off and in again the power cord.
After you unplug and plug the power cord in while the unit is in standby mode and also the power is being supplied to a terminal board, the unit will start supplying the power to the board with time delay according to the setting.
The power indicator lights up red first and it turns orange when the power starts being supplied to the board.
Off: Not display the clock.
On: Display the clock.
The clock is displayed at the lower left of the screen when 
button is pressed.
Clock Display
1 0 : 0 0
Note: When “PRESENT TIME SETUP” is not set, the clock is not displayed even if “Clock Display” is “On” (see page 25)
| Sets All Aspect mode (advanced aspect setting) or default aspect mode. | |||
| With each press of | button, the aspect changes in the selected mode. | ||
| Off: | Default aspect mode | ||
All Aspect | On: | All Aspect mode | ||
Aspect mode of each setting is as follows: | ||||
| ||||
| (Example: HD signal) |
| ||
| Off | |||
| On 4:3 (1)→4:3 (2)→4:3 Full→Zoom1→Zoom2→Zoom3→16:9→14:9→Just1→Just2 | |||
Serial Slot | Slot1 | Slot2 | Slot3 | |
Selects the slot which communicates serial. | ||||
Select | ||||
Note: The setting of an external command can be set only from the fixed serial terminal. (see page 11) | ||||
| ||||
Normalization
When both main unit buttons and remote control are disabled due to the “Button lock”, “Remocon User level” or “Remote ID” adjustments, set all the values “Off” so that all the buttons are enabled again.
Press the | button on main unit together with | button on the remote control and hold for more than 5 seconds. The |
“SHIPPING” menu is displayed and the lock is released when it disappears.
37
